Length of Rods on Polar T-Handle Latch # PLR5730

Question

Question:

How long are the rods for this when fully extended and when retracted? And are they flattened or circular at the ends?

asked by: Dan

0

Expert Reply:

The two rods on the Polar T-Handle Latch # PLR5730 are each 48 inches long. When locked the assembly will have an overall length of 97-3/4 inches long and when unlocked the overall length is 96 inches.

The ends of each rod are circular.

expert reply by: Chris R

0

Answer 1

I can offer what we have, though not make something work, it really depends on what size your wheel is. There is a 3,500 lb Timbren Axle-less system that is designed for use with larger tires and fits a hub with a 6 on 5-1/2" bolt pattern,…

view full answer...

Answer 2

The Kenda K353 Bias Trailer Tire - 5.30-12 - Load Range C #AM10066 has a speed rating of 65 mph and like you mentioned a max load capacity of 1,045 lbs at 80 psi. However you should make sure that the combined maximum load rating is higher than the…

view full answer...

Answer 3

On the inboard side of the Timbren Silent Ride Suspension #TSR7000T05 there are two flanges that have two slotted bolt holes on them. That is where the crossmember attaches. Each axle would be rated for 7k so with this you would have 14k of axle…

view full answer...

Answer 4

To run a charge line to your battery you will first need to install a 7-Way on your trailer. This can be done using the Epicord 7-Way Molded Trailer Plug with Junction Box #277-000141. The Black wire in the junction box is the one that will carry…

view full answer...

Answer 5

There are a few differences between the standard Firestone Ride-Rite Air Helper Springs #F2598 and the Firestone Ride-Rite Red Label Extreme Duty Air Helper Springs #F2706, which are the correct fits for a 2015 Ram 2500. You mentioned one, which is…

view full answer...

Answer 6

If the diameter of your axle was 3 inches the kit part #K71-385-00 would work to allow you to move the springs in relation to the axle. Based on the size of the trailer you'd most likely have a smaller diameter axle like 2-3/8 inch like what…

view full answer...

Answer 7

According to my Redline representative, all of the #L4080 T-Handle locks are keyed alike. I have confirmed this myself by pulling a few of them off the shelf in the warehouse. They all use the same key number, so if you order four of them, they…

view full answer...

Answer 8

Yes, the Curt Front Mount Hitch #31367 will indeed fit a 2012 Toyota FJ Cruiser. It has a 350 lb vertical load limit so it can certainly be used for a spare tire mount. A really good option for a carrier is our etrailer Hitch Mounted Spare Tire…

view full answer...

Answer 9

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 10

To create barn doors out of your ramp door, you will need hinges and a latch. I suggest a latch/lock system like the Universal Cam-Door Lock for Enclosed Trailers - 1" Keeper, #383200. This will use a 3/4 inch diameter pipe that…

view full answer...

Length of Rods on Polar T-Handle Latch # PLR5730

Product Page this Question was Asked From

Continue Researching