Torklift SuperHitch Recommendation for 2003 Ford F-250

Question

Question:

I have an 03 Ford F250 Lariat 7.3 with 37 and 3/4 in frame thats from outside to outside. I want to know if the torklift super hitch will fit my truck and how much?

asked by: Trevarr P

0

Expert Reply:

For your 2003 Ford F-250 with the frame dimensions you mentioned the correct Torklift SuperHitch you need is the part # TLF1002.

The dimensions you listed are compatible with the fit of this hitch.

expert reply by: Jameson C

0

Answer 1

Sure will! 2-1/2" shank ball mounts like the Curt Ball Mount #C79NR you mentioned are made to a standard size allowing them to be installed in all trailer hitches that are 2-1/2". You'll have zero issues using it in the Draw-Tite…

view full answer...

Answer 2

The trailer hitch I recommend for a 2017 Ford F-350 is the Draw-Tite Trailer Hitch Receiver part #DT45508 which is a fit for all models whether you are replacing a factory hitch or just adding one yourself. It has a class v rating with 2-1/2"…

view full answer...

Answer 3

I have another option for you but No, you cannot replace the 2-5/16" ball on the Blue Ox #BLU25XR with a 2" hitch ball. Instead I recommend going with the Gen-Y #325-GH-924 which has a similar rise/drop at 6" either way, and includes a…

view full answer...

Answer 4

For that much tongue weight the best option for a weight distribution system would be the Blue Ox SwayPro part #BXW2003. This has a tongue weight range of 1,500-2,000 lbs and has built in sway control within the head of the system where it holds the…

view full answer...

Answer 5

The Draw-Tite Class V receiver hitch you'd looked at, part #DT45508 would indeed be a fit for a 2015 Ford F350. The existing hitch would need to be removed, and this hitch would bolt in its place. This hitch would be a great choice for your…

view full answer...

Answer 6

The weight carrying capacity of the Draw-Tite DT45508 Trailer Hitch is 18,000 pounds towing and 2,000 pounds tongue weight capacity. With weight distribution the trailer weight capacity remains 18,000 pounds and the tongue weight is increased to…

view full answer...

Answer 7

The current Torklift tie down part #TLD3101 that you have installed on your 1997 Dodge Ram 3500 only fits if you have the factory hitch. If you go with the SuperHitch part #TLD1100 you would need to change your rear tie down to the part #TLR3503.

view full answer...

Answer 8

The longest extension available that will work with the factory trailer hitch receiver on your 2014 Dodge Ram 3500 is the Trailer Hitch Extender #e48YR. You will need to measure from the center of the hitch pin hole on your trailer hitch receiver to…

view full answer...

Answer 9

We offer three Class V Curt hitches for your 1995 Dodge Ram 3500 4WD Dually Diesel that can be seen on the linked page. All share the same 2400-lb tongue weight (TW) and 16K maximum trailer weight ratings, and all increase to 17K GTW if used with a…

view full answer...

Answer 10

The B and W hitch part #BWHDRH25132 that you referenced has been confirmed as a fit for your 1998 Dodge Ram. I confirmed this with B and W. It looks like the hitch will sit up higher than your factory hitch since the vertical mounting brackets are…

view full answer...

Answer 11

My first thoughts on your Voyager WiSight Wireless System, #WVOS541, are, there is an issue getting a strong wireless signal. You've checked power to the monitor but what about the camera and antennae, please verify that too. If you are getting…

view full answer...

Answer 12

I have attached for you below the pairing procedure for the Voyager WiSight Wireless RV Backup Camera System part #ASA84YR. Please note, a mistake I have made in the past was applying power to the camera too soon, this cannot be done until the…

view full answer...

Torklift SuperHitch Recommendation for 2003 Ford F-250

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching