bing tracking image
Q & A Icon

Trouble Pairing Camera and Monitor on Voyager WiSight Wireless RV Backup Camera System  

Question:

Additional diagnostic steps, camera has ground and power rebooted both multiple times to try and pair rear camera on trailer to receiver all other 3 cameras are perfect

0

Expert Reply:

I have attached for you below the pairing procedure for the Voyager WiSight Wireless RV Backup Camera System part # ASA84YR. Please note, a mistake I have made in the past was applying power to the camera too soon, this cannot be done until the monitor is hooked up and in pairing mode. If you have further issues once you have checked this please just let me know.

This system has Auto-Pairing function. If your monitor is not receiving a signal from the camera; the two may not be paired correctly.
1. Monitor must be connected to 12 Volt DC power supply.
2. Press the SELECT/PAIR button on the front of the monitor expected mode & select the appropriate AV source (AV1-AV4)
3. Press and hold the "SELECT/PAIR" button on the front of the monitor for 5 seconds and release. (Monitor will display "PAIRING START")
4. Apply 12 Volt DC power to the camera.(Camera 1 - Camera 4 corresponding to Monitor's AV1 - AV4) OPERATION
1. Press the power button on the monitor and turn on your vehicle's parking lights.
2. In the top left corner of the monitor, you will see the signal strength meter.
3. Adjust the suction cup bracket to provide the best viewing angle.
If done correctly, monitor will display "SAVE DATA". If pairing is not successful, the monitor will display "PAIRING FAIL". If you receive this message, repeat steps 3-4.

expert reply by:
0
Conner L

Dennis

4/30/2024

Does turning on the lights power the camera?

Product Page this Question was Asked From


Q & A Icon

Continue Researching

See More Q&A Expert Answers >>