Summer Starts Here - Save up to 70%
Customers prefer these similar products
Hub-and-rotor assembly works with 7,000-lb Dexter disc brakes. E-coat finish protects against corrosion. Vented design prevents heat-related damage. Inner bearing (25580), outer bearing (14125A), races, grease seal, and grease cap included.
Features:
Specs:
Videos are provided as a guide only. Refer to manufacturer installation instructions and specs for complete information.
Speaker 1: Today we're going to take a look at the Dexter 12-and-a-quarter inch e-coat hub and rotor assembly with the eight on six-and-a-half inch bolt pattern for 7,000 pound Dexter axles. Now, this hub and rotor assembly is designed to work with 7,000 pound Dexter axles with disc brakes. The rotor itself has a machine process, which will minimize run out and warping. That will help keep contaminants from getting in between your rotor and your hub. The rotor is a van tip design you can see right here. That dissipates the heat, so it regulates temperature to prevent over-heating.
It is a cast iron construction, so it does provide strength and durability. It has a nice e-coat finish over it to protect against corrosion and wear.This part number will include everything shown here on the table; the hub and rotor, the inner, the outer bearings. The bearing races are included. They are just pre-installed in the hub. The double lip grease seal, the grease cap, the eight wheel lug nuts and these are the five-eighths inch by eighteen lug nuts, and all these parts are made in the USA.A few specs on this; it is designed to fit the axle of 7,000 pound Dexter axle with disc brakes.
The wheel size it will fit on this is a 16 inch, 16-and-a-half, and 17 inch. The bolt pattern, again, is an eight on six-and-a-half inch bolt pattern. The wheel studs here on this are a five-eighth inch diameter. Rotor diameter itself, from edge to edge, is 12-and-a-quarter inches.Now, the information on the bearing races and seals, the bearings, the inner bearing is a part number 25580. It has a 1.75 inch inner-diameter.
The outer bearing is part number 14125a. It has a 1.25 inner-diameter. The races, we mentioned, are pre-installed. The grease seal is included and it's part number gs-2250dl. Inner-diameter is 2.25 inches.
Outer-diameter is 3.376 inches. The grease cap is included. As we mentioned, the eight five-eighths by 18 lug nuts.That should do it for the review on the Dexter 12-and-a-quarter inch e-coat hub and rotor assembly with the eight on six-and-a-half inch bolt pattern for 7,000 pound Dexter axles.
Do you have a question about this Trailer Hubs and Drum?
Info for this part was:
At etrailer.com we provide the best information available about the products we sell. We take the quality of our information seriously so that you can get the right part the first time. Let us know if anything is missing or if you have any questions.
Thank you! Your comment has been submitted successfully. You should be able to view your question/comment here within a few days.
Error submitting comment. Please try again momentarily.