Thank you! Your comment has been submitted successfully. You should be able to view your question/comment here within a few days.
Error submitting comment. Please try again momentarily.
Flush bushing is designed to fit flush into the fitting it connects to. 1-1/2" Hub x 2" spigot. Sturdy ABS plastic construction.
Features:
Videos are provided as a guide only. Refer to manufacturer installation instructions and specs for complete information.
Ellen: Hey everyone, I'm Ellen here at etrailer.com, and today we're going to be taking a look at the LaSalle Bristol flush bushing. This is going to help you to reduce the line size in your RV sewer system. So you can go from a two inch pipe down to an inch and a half. So we're going to have a one and a half inch hub to a two inch spigot. So as far as the actual dimensions are going to be a little bit different from that, but it's still going to fit in your piping. So the outer diameter here is about 2-3/8" in diameter.
The inner diameter here is about 1-7/8. So this is designed to fit over your pipe and this fits into it. So it's going to connect those down and reduce that size, so you can get connected to your smaller size there.As far as the depth, it's about 7/8" to that outer lip. It is made out of a durable ABS plastic construction, and ABS plastic is just stronger and more abrasion resistant than your typical plastic so it should last you for a long time. That's pretty much going to do it for our look at the LaSalle Bristol flush bushing.
If you need any other accessories or replacement parts for your RV sewer system, we do have a lot of options available here at etrailer.com, so definitely check them out. Thanks for watching.
Average Customer Rating: 3.5 out of 5 stars (2 Customer Reviews)
Flush bushing is designed to fit flush into the fitting it connects to. 1-1/2" Hub x 2" spigot. Sturdy ABS plastic construction.Looking good... just another important piece in the puzzle... of a water collection diversion system... being built before the winter storms hit
... and the back of my lot/project footings even gets a chance to flood as I know they will
the O.D. is correct but the I.D. is to small for 1 1/2" ABS pipe the ribs inside are not designed for a glue fitting. will have to use a Drimmell to make it fit.
Info for this part was:
At etrailer.com we provide the best information available about the products we sell. We take the quality of our information seriously so that you can get the right part the first time. Let us know if anything is missing or if you have any questions.
Jenny N.
4/28/2022
The inner diameter of the bushing should be approximately 1.87 inches in diameter in order to slide over the 1.5 pipe. It could be that it is running on the smaller side and the pipe is running on the bigger side