Tray Trim Kit for Kwikee SuperSlide II RV Storage Slide Out Tray Assembly - 24" Wide

Kwikee Accessories and Parts - LC370676

Build an RV sliding cargo tray with this trim kit, a rail kit (sold separately), and a plywood bottom (not included) to easily retrieve gear without crawling into your compartment. Included trim pieces prevent cargo from sliding off during travel.

Features:

• Trim kit pairs with a rail kit (sold separately) to form a slide-out tray for your RV or camper's cargo compartment
  • Requires carpet-covered plywood (not included) for the bottom
  • Store and retrieve camping and hiking gear, tools, and power cords without crawling into the compartment
• 2 End trim pieces help prevent your belongings from sliding off the tray during travel
• 3 Mid-rail trim pieces provide additional support for your cargo
• Durable steel construction with rust-resistant powder coat finish
• Easy, rivet-mount installation
  • Includes 2 jig cross strips, 4 jig knee braces, and 40 rivets
• Made in the USA

Specs:

• Fits: cargo compartment openings 28" wide
• Tray weight capacity (when fully assembled and installed): 800 lbs
• Overall width of end trim pieces: 24"
• 1-Year warranty

Pair this tray trim kit with a rail kit (sold separately) and a carpet-covered plywood bottom (not included) to create a complete slide-out tray for the cargo compartment in your RV or camper. The complete tray lets you store and organize camping and hiking gear, tools, and power cords, so your compartment doesn't become too cluttered. It also glides out when you need it so that you don't have to crawl into the dirty or cramped compartment in order to retrieve your belongings.

Determining Which Tray Trim Kit You Need

To figure out which tray trim kit you need, measure the width of your cargo compartment opening, and then subtract 4. For example, for this 24" trim kit, your cargo compartment should measure 28" wide. This ensures that the tray would have the proper clearance as it slides in and out.

If your cargo compartment is smaller or larger, please reference the table below to determine which trim kit you would need.

Find the rail kit you need to complete your setup:

The rail kit needed to complete your SuperSlide II is sold separately. To determine which rail kit you need, simply measure the overall inside length of your cargo compartment. Whatever measurement you get is the minimum length of the rail kit that you will need. Depending on your RV or camper setup, you might need to go with a rail kit that is slightly smaller than your cargo compartment to account for any potential clearance issues.

Installing the Trim Kit

Installing the Trim Kit

This trim kit includes 2 end trim pieces, 3 mid-rail trim pieces, 2 jig cross strips, 4 jig knee braces, and 40 rivets. Once the rail kit (sold separately) has been assembled, mount the end trim pieces and the mid-rail pieces to the rails using the rivets. Then after the carpeted wood bottom (not included) has been installed, use the rest of the rivets to install the jig cross strips and jig knee braces.

Once the tray has been completely assembled, place it onto the floor of the cargo compartment, and make sure there's adequate clearance for the compartment door. Depending on your setup, you may need to raise the rails with 2x4s (not included). Once the tray is fully aligned, use the integrated mounting tabs on the rails and hardware (not included) to bolt it down.

370676 Lippert Components (LCI) Tray Trim Kit for Quickee Super Slide 2 RV Sliding Storage Tray Assembly - 24" Wide

Alternate part number: 905849024