Rail Kit for Kwikee RV Storage Slide Out Tray Assembly - 22" Long - 400 lbs

Kwikee RV Cargo Slides - LC370794

Build an RV sliding cargo tray with this rail kit, a tray trim kit (sold separately), and plywood bottom (not included) to easily retrieve gear from your compartment. Included rails slide tray out so you don't have to crawl into your compartment.

Features:

• Rails pair with a tray trim kit (sold separately) to form a slide-out tray for your RV or camper's cargo compartment
  • Requires carpet-covered plywood (not included) for the bottom
  • Stores camping and hiking gear, tools, power cords, and more
• Sliding design eliminates the need for you to crawl into a dirty or cramped compartment
• Spring-loaded latches lock the rails in the stowed position to prevent it from sliding out while traveling
• Durable steel construction with rust-resistant powder coat finish
• Easy, bolt-on installation into your cargo compartment
  • Pre-assembled rail assemblies are included
  • Wood screws and 5/16" hardware are not included
• Made in the USA

Specs:

• Fits: RV cargo compartments at least 22" long
• Tray weight capacity (when fully assembled and installed): 400 lbs
• Overall exterior dimensions (per assembled rail): 4" wide x 7" tall
  • Length when fully stowed: 22"
  • Length when fully extended: 45-1/8"
• Mounting hole spacing (per assembled rail):
  • Between 2 holes: 4-7/8"
  • Between the holes on the ends: 19-1/2"
• 1-Year warranty

Pair this rail kit with a tray trim kit (sold separately) and a carpet-covered plywood bottom (not included) to create a complete slide-out tray for the cargo compartment in your RV or camper. The complete tray lets you store and organize camping and hiking gear, tools, and power cords, so your compartment doesn't become too cluttered. It also glides out when you need it so that you don't have to crawl into the dirty or cramped compartment in order to retrieve your belongings.

Determining Which Rail Kit and Tray Trim Kit You Need

To determine which rail kit you need, simply measure the overall inside length of your cargo compartment. Whatever measurement you get is the maximum length of the rail kit that you will need. For example, for this 22" rail kit, your cargo compartment should measure at least 22" long. If your cargo compartment is a lot longer than 22", you will need a SuperSlide I or SuperSlide II rail kit.

The tray trim kit you can use to complete your storage slide-out tray assembly is sold separately (LC380319). This trim kit measures 32" long, and it fits cargo compartment openings no smaller than 36". This ensures that the tray would have the proper clearance as it slides in and out.

Installing the Rail Kit

This rail kit includes pre-assembled rail assemblies. First you will need to install all of the pieces of the tray trim kit (sold separately) to the rails. Then install the carpeted wood bottom to the rails with wood screws (not included) for a full-length tray floor.

Once the tray has been completely assembled, place it onto the floor of the cargo compartment, and make sure there's adequate clearance for the compartment door. Depending on your setup, you may need to raise the outer rails with 2x4s (not included). Once the tray is fully aligned, use the integrated mounting tabs on the rails and hardware (not included) to bolt it down.

370794 Lippert Components (LCI) Rail Kit for Quickee RV Sliding Storage Tray Assembly - 22" Deep

Alternate part number: 905966000