How Far Can The 90 Kwikee SuperSlide RV Storage Slide Out Tray Extend

Question

Question:

How far can this 90# tray slide out in each direction?

asked by: Chad H

0

Expert Reply:

Lippert didn't have the dimensions for how far out the Rail Kit for Kwikee SuperSlide II RV Storage Slide Out Tray Assembly # LC370762 extends in either direction so I had one pulled from stock and did a bit of testing. On one end of the assembly there's a latch that locks into place prevent the tray from sliding in that direction. If you lift the latch and allow the tray to roll that way there is nothing to stop it from fully rolling out of the track.

On the other side, which I'd assume you'd place towards the compartment door you'd prefer to mainly use it can extend out 60" past the tracks, giving you roughly 66% extension. Since this is just the side rails you'll also need to pick up a trim kit for your desired width and then some plywood from your local hardware store for the base. We currently offer the follow width trim kit sizes:

24" # LC370676
27" # LC370678
30" # LC370680
32" # LC370682
33" # LC370684
37" # LC370690
39" # LC370692
44" # LC370755
51" # LC370759

expert reply by: Kevin C

0

Answer 1

You would need to support the Rail Kit for Kwikee SuperSlide II RV Storage Slide Out Tray Assembly #LC370762 the entire length and would not want to cantilever over the 8" drop. To complete the tray you'll need to choose the appropriate size…

view full answer...

Answer 2

If your current TorkLift steps are the 2-to-5 step GlowStep Revolution models with 27-7/16" wide mounting bases, part #TLA8002, #TLA8003, #TLA8004, or #TLA8005, you can use the TorkLift Add-A-Step, part #TLA8001. If your Glow Steps aren't…

view full answer...

Answer 3

I have a solution for you but we don't have a replacement bracket to replace the support and bolt that was broken on your TorkLift GlowStep similar to the #TLA8004 . Instead you would need to use the Add-A-Step for TorkLift GlowStep Revolution…

view full answer...

Answer 4

I recommend Valterra Deadbolt Lock for RVs part #L32CS3108 that fits between 1-3/8" to 1-3/4" thick RV doors and with 2-3/8" from center of face hole to leading edge of door. Please let me know if your door does not match these…

view full answer...

Answer 5

The issue is that there isn't a "standard" lip across RV's for drawer clearance. But I can tell you that the MORryde RV Cargo Sliding Tray #MR93FR has a 1.57" clearance so you will need the Height Adjustment Kit #MR34VR if your…

view full answer...

Answer 6

I attached a picture that shows all of the dimensions of the MORryde Sliding Tray for RV Cargo Compartment #MR93FR. This picture is actually in our product pictures already but it's buried pretty far down on the list of them.

view full answer...

Answer 7

Adding suspension enhancement like the Timbren #TNRTTN you referenced does substantially help with load support and reducing sag, however it does not increase the payload capacity of your truck. Your 2012 Nissan Titan Pro 4X will have the same 1850…

view full answer...

Answer 8

I believe what you are looking for is the Kwikee SuperSlide II Tray Assembly Kit for RV Cargo Compartment #LC370762. This is 90" deep so that matches but the smallest trim piece we carry width-wise is part #LC370676 which is 24" so this is…

view full answer...