Trim Kits for Kwikee SuperSlide II Tray Assembly Kit for RV Cargo Compartment

Question

Question:

Kwikee SuperSlide II Tray Assembly Kit for RV Cargo Compartment - 60 Deep What is the trim part number and do you sell it?

asked by: Shayne L

0

Expert Reply:

We do have the trim kits available for the Kwikee SuperSlide II Tray Assembly Kit for RV Cargo Compartment - 60 Deep # LC370787 that you referenced. You just need to choose from the following to match the width of your compartment:

24" - # LC370676
32" - # LC370682
48" - # LC370757

You'll also need to acquire some plywood at your local hardware or lumber store to complete this setup.

expert reply by: Jon G

0

Answer 1

Replacing the passenger tires you have on your trailer as soon as you can is a smart idea as passenger vehicle tires are not rated properly for trailer use and they would be very likely to fail. In the tire size of ST225/75R15 the best option is the…

view full answer...

Answer 2

The distance from the floor that the MORryde Sliding Tray for RV Cargo Compartment #MR39FR is mounted on to the carpeted surface of the tray is approximately 1.75"

view full answer...

Answer 3

For sag from towing a trailer the best recommendation I can make is actually a weight distribution system. Suspension enhancement will help level your truck while towing. But the advantage to a weight distribution system is that it levels the vehicle…

view full answer...

Answer 4

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 5

No, it really isn't but I have a solution. The MORryde RV Generator Slide Out Tray item #MR79RR is designed to be mounted in storage compartments. It needs a sturdy base to support the weight of your generator and you're not going to be able…

view full answer...

Answer 6

Another wire or harness is not needed on the 2023 Honda CR-V for the install of the Curt 4-Way Wiring Harness #C56370, but you do have to add 20 amp fuse to location #17 in the fuse box.

view full answer...

Answer 7

Hey Gregory, the MORryde RV Cargo Sliding Tray CTG60-2048W part #MR94FR weighs 73 lbs.

view full answer...

Answer 8

Thanks for reaching out, Michael! The Dexter Electric Trailer Brakes #K23-086-087-00 are compatible with 3,500 lb axles and have the standard 4-bolt pattern so if that matches the specs of your axle then this will definitely work for your…

view full answer...

Answer 9

The Dexter 8-427 hub is no longer available. Even looking through Dexter's site the only references to it are replacement bearings. You can use a wheel with a larger pilot hole as long as the wheel attaches to the hub using lug nuts and not…

view full answer...