Replacement 12" Rotor for Dexter Disc Brakes - 6 on 5-1/2 - E-Coat - 6,000 lbs

Video Transcript for Review of Dexter Axle Trailer Brakes - K71-637-00

Hello everybody, this is Jeff at etrailer.com. Today, we're gonna take a look at this replacement 12 inch slip on rotor for 6,000 pound Dexter Disc Brake Assembly. It has a six on five and a half inch bolt pattern and an E-coat finish. Now, this replacement rotor will fit your 6,000 pound Dexter Disc Brake Assembly. This is a cast iron construction, provides strength and durability and if you notice it is a vented design which will allow airflow to regulate the temperature to prevent overheating of the rotor. It does have a nice E-coat finish to it to protect against corrosion and wear and it is made in the USA.

A few specs, again, diameter from one edge to the other is 12 inches and the bolt pattern on this is a six on five and a half inch and the way you can measure that, basically it's six holes and because there's an even number of holes you can measure the bolt pattern by just taking either hole and measure from the center of that hole directly across to the center that's right across from it. So, again, you pick any hole you want and measure from the center of that hole directly across and it will measure five and a half inches. But that should do it for the review on this replacement 12 inch slip on rotor for 6,000 pound Dexter Disc Brake Assembly, six on five and a half inch bolt pattern with an E-coat finish..