Most Popular HappiJac
Videos
for HappiJac
Help Articles
for HappiJac
Expert Answers
for HappiJac
I'm assuming your 2024 F-250 has the 6-3/4' bed. If that is correct, the right tie-downs are in fact the #TLF3008 and #TL77CR. TorkLift has accounted for the bed access steps on the 2024 model and confirmed these will fit your truck.
view full answer...You are correct the HappiJac Camper Tie-Downs #LC182904-182971 are the correct kit for your 2013 GMC Sierra 3500 with a regular cab and 8' bed. I would highly recommend looking at the Torklift Front #TLC2215 and Rear #TLC3212 as a better option…
view full answer...We have run into this quite a few times in the past, and the best option will be replacing the Lance 7-pin connector with a standard 7-way blade connector like the #PK12706. This will give you a standard 7-way connector to plug into the factory 7-way…
view full answer...Since the motors work when connected directly to power and you are getting the green light on the remote, it sounds like everything is operational. The remote with the Replacement Circuit Board w/ Wireless Remote for HappiJac Electric Truck Camper…
view full answer...If you're looking for just the L-bracket for your HappiJac Electric Truck Camper Jack System #LC736514-ELKIT then you'll need part #LC182492. The flat bracket can be swapped out with part #LC182494 and the swing brackets can be replaced with…
view full answer...Hey Mark, thanks for the question, and while we have exactly what you're looking for, it's actually a different part number (the one you mentioned is for a long bed). I went ahead and verified for you the correct SuperHitch for your 2018…
view full answer...The HappiJac Electric Truck Camper Jack System #LC736514-ELKIT is the replacement kit for the 4100 series jacks that you have. It uses the same Replacement Jack #LC736514 and Motor Head #LC759927 for the front and rear jack positions.
view full answer...The support braces in the HappiJac Truck-Mounted Camper Tie-Downs #LC182860 are going to attach to the cross frame to provide support for the anchors which will bolt through the bed wall and into the braces. The rear anchors will bolt through the…
view full answer...Yes, the Replacement Jack for HappiJac Truck Camper Jack System part #LC736514 (Model 4220) will fit your HappiJac Truck Camper Jack System Model 4150. If you need a new gearbox/motor then we have that as well, the Replacement Motor and Gear Head…
view full answer...That's a good question Mark, and yeah I agree, it would make sense for the screws to be on the bottom when using the Gen-Y Anti-Rattle Clamp for 2-1/2" Hitch Receivers #GY28XR. It'll work either way, but they're on the top mostly for…
view full answer...Well that stinks to hear; I'm sorry someone was lousy enough to steal from you. And while we do have an option for you, the older wired remote is not available as a replacement part. So what you would need to do instead is replace the circuit…
view full answer...Having the replacement cable #LC149557 between the #LC723915 and the 723914 and then doing a reset is all that is required to sync the two. To reset the receiver press the ACC-In and ACC-out button at the same time. If this does not work you can also…
view full answer...
What our customers are saying:
"Very helpful/friendly Customer Service. Competitive Pricing. Shipping was Fast."