Pro Series

To replace your converter you have two options: Option 1: Completely replace the converter and AC/DC distribution panel. You could use a power center like the #PD4135K or a larger one if you'd like a higher amperage converter and more AC circuit…

To add a hitch to your 2024 Jeep Grand Cherokee L, I recommend the Draw-Tite item #DT42GR. This hitch is custom fit and bolts to your Jeep with included hardware. This is a class III hitch with a 2" receiver. It has a 7,500 lbs towing capacity…

I have good news, our trailer jack that has a 2 inch outer diameter part #DL74MR would fit and work well. While it has a 1,000 lb weight capacity that does not mean 1,000 lb total trailer weight capacity. That capacity is the tongue weight capacity…

I spoke with my contact at Reese and he sent me dimensions of the Pro Series Jack, item # PS14009503676. I have included a drawing containing these dimensions for you to review. There is no owners manual included with these Jacks at this time. The…

The weight capacities of the Reese weight distribution shank part #RP69FR is the same regardless of what adjustment holes you use on it. This has a 1,200 lb tongue weight capacity.

I would use a protractor, see photo, place the protractor on the edge of the inside of one side of the trailer frame and the other inside edge of the trailer frame should be parallel with the 50 degree line on the protractor. Another way to verify…

I believe we have just what you're looking for. Check out the Curt Adjustable Weight Distribution Shank #C17100. This weight distribution shank has 7 holes for adjustment, will work with 2" trailer hitches, and has a maximum weight capacity…

Hey there Gary, thanks for the photo and yes the etrailer Bolt-On Swivel Mounting Plate for 3,500-lb Trailer Jacks with a 5/8" Swivel Pin #e52JR will indeed work with your Round, Pipe Mount Swivel Jack #TJP-5001S-B.

I pulled one of the #RP63971 weight distribution shanks from our warehouse to measure, and the distance from the center of the pin hole to the rear edge of the shank is 4 inches. I am including a picture showing the measurements I took while I had…

The Dutton-Lainson Square Swivel Jack #DL22340 has a mounting plate designed to fit trailer frames with a height of 3" - 5". I have attached a dimensional drawing below with all of the bolt spacing for your reference.

The only differences between the Demco Trailer Coupler #DM14976-52 and #DM88XR are the colors and the mounting bracket design. The part DM14976-52 is silver and has a straight, or no-drop, design with the bottom of the coupler being towards the top…

We don't currently have any customer submitted photos for the Brophy Heavy Duty Cable Camper Jacks #CX74, but we do for the lower capacity #CJ74, which uses the same lift brackets. From the edge of the tube to the lift bracket is approximately…