Rightline Gear Anti-Theft Trailer Coupler Ball and Lock Review Video

To wire two 6-volt batteries in series to produce 12-volts, you would connect the load to the positive terminal of battery #1. Connect the negative terminal of battery #1 to the positive terminal of battery #2. Ground the negative terminal of battery…

When installing the Fastway e2 Weight Distribution w/ 2-Point Sway Control #FA94-00-0600 referenced in your question, you will need a torque wrench capable of 250 ft-lbs of torque. With the weight distribution engaged, you will begin with the angle…

I recommend using Grade 5 1/2" x 4" bolts to install the Demco Channel Tongue Trailer Coupler part #DM12717. These would allow for the full weight capacity of the coupler to be achieved. These can be picked up at most local hardware…

My best recommendation is the etrailer Surge Brake Coupler Lock #e98887. This lock fits into either one of the two pin holes of your coupler #12564. This locks your latch into place so one can't disconnect it from your tow vehicle. It also works…

I spoke with my contact over at Demco about coupler #12564. From the top (outside) of the coupler above the mounting holes down to the center of the mounting holes measures 1.029". What brand is the coupler you have now because the 1 inch…

The Demco Trailer Coupler part #12564 that you referenced does not come with mounting bolts. You would need to supply them. A local hardware store would have no problem getting you setup with nuts and bolts. The hole diameters are 1/2 inch.

The hole diameters for the Demco Channel Tongue Trailer Coupler item #12564 are 1/2 inch. It is recommended to use grade 8 hardware to attach the coupler to your trailer frame. You can find these bolts at a local hardware store as they do not come…

I do have a solution for you but there are no front mount trailer hitches available for the 2003 Honda Element. What I recommend is a Trailer Valet XL trailer dolly such as #TVXL2 which has a 2 inch ball or #TVXL25 which has a 2-5/16 inch ball. These…

I did some checking and for your MaxxFan 4900K vent the MaxxAir II RV and Enclosed Trailer Roof Vent Cover #MA26JR that you referenced is a confirmed fit.

I recommend using a Master Lock Trailer Hitch Receiver Lock and Coupler Lock Set #3794DAT for the CE Smith Multi Sport Plus Boat and Kayak Trailer #CE48870. With this set you get a coupler lock for when you are towing the trailer as well as a storage…

The Malone MicroSportXT Trailer - Aluminum Wheels - Retractable Tongue - 13' Long - 375 lbs #MPG460XT is a great option for the storage reasons you stated. The Rhino-Rack Nautic Roof Kayak Carrier w/ Tie-Downs - Side Loading - Clamp On #RR570…