MaxxTow Hitch Receiver Lock Review Video

If the trailer is less than 1 inch off of being perfectly level either up or down then it will be perfectly fine. Having it slightly higher would be better because presumably the tongue weight of the trailer will pull it down a little. You could also…

You will be able to slide the Lock N Roll 3-Position Adjustable Channel Bracket #336TS505 into the 2" receiver on the trailer. This will allow you to bolt in the Demco Trailer Coupler #DM14976-52 to attach to a 2" trailer ball.

Your 2001 Volvo V70 wagon can be equipped with any of three choices in a 1-1/4-inch Class II hitch. All hitch options can be seen on the link provided. Since you will be using a large-capacity 4-bike rack with this hitch, the Yakima DoubleDown Ace 4…

The Class II ball mount we offer with the tallest rise is the Curt #C45028. This ball mount has a rise of 5-3/8 inches. This gives you a height of 18-3/8 inches, still short of your 22-3/4 inch coupler height. Even if you used a hitch ball similar to…

Ideally a hitched trailer will be level to the ground. We often recommend starting off with the hitch ball being a bit higher - an inch or so - than the top of the coupler on the level trailer since once hitched there will be a degree of squat in the…

The only difference between buying the Channel Bracket #336TS505 and the Channel Mount #336VS503 separately is only the fact that they are purchased separately. It's the same thing so grab whichever one saves you the most money. ON the trailer…

Class I and Class II hitches both have a 1-1/4 inch receiver opening. The difference is that a Class I hitch has a lower tongue weight rating, usually 200 pounds and a lower towing rating, usually 2,000 pounds. A Class II hitch usually has a tongue…

The TowSmart Trailer Coupler Lock Kit - 1-7/8, 2, and 2-5/16 Couplers w/ Hitch Lock & Coupler Lock #TS84FR uses different lock cores/keys for different kits. Although they are not 100% unique, the odds that someone would order the same lock set…

We often include clearance measurements when we do a hitch installation videos for products like the Curt #11000, but in the case of your 2010 Golf we do not happen to have done an installation video of this particular hitch on your particular…

The Class I 1-1/4 Inch Hitch, part #C11000 on your 2011 Volkswagen GTI. It is located right under the rear fascia of your vehicle. It measures so that the top of the ball mount is approximately 8 inches from the ground as you can see on the attached…

The Curt bar #C45028 (5-3/8 inch rise or 6-inch drop) you referenced is one of 3 Curt drawbars we currently offer that will have a 5 inch or more rise in the shank. The reason other shanks may have a different rise is because it may have a different…

Width usually isn't a consideration when it comes to choosing a drawbar. Folks are typically concerned about getting a drawbar that places the trailer ball at the proper height so the trailer is level when it's being towed. I'll link you…