Gen-Y Torsion Weight Distribution Shank Review Video

Yes, the Gen-Y Torsion weight distribtuion shank part #325-GH-1102 that you reference will work great with your Pro Series weight distribution as it was designed to have same bolt pattern.

If you want to just add on some sort of extension you can use Safety Chain Quick Link #C82932 which has a working load limit of 3300-lbs. This will give you about 3-inches additional length. Ideally trailer safety chains will be one continuous…

Our highest capacity hitch for your 2021 Chevy Silverado 3500 Dually is the TorkLift SuperHitch Magnum Trailer Hitch Receiver item #TL74FR. This custom fit hitch bolts directly to your Silverado's frame with included hardware. It includes…

I went out into our warehouse and grabbed a 2-5/16" Hitch Ball #C40085 to measure and found it is from top to bottom 5-3/4 inches tall.

The Gen-Y Torsion Weight Distribution Shank #325-GH-1202 has plenty of capacity for your 7600-lb travel trailer. This shank is compatible with any brand of weight distribution head assembly and will give you a less jerky ride thanks to its rubber…

The picture you submitted shows a weight distribution head that has a 1,000 lb tongue weight and 10k total trailer weight when the spring bars aren't connected.

The Gen-Y Torsion 2-Ball Mount w/ Stacked Receivers #325-GH-1324 that you referenced doesn't have the same features as weight distribution or sway control so it's hard to compare them. It will cushion the ride quality when you are…

Curt recommends the use of 250 ft/lbs of torque when tightening the nuts of their hitch balls with a 1 inch diameter shank like the part #C40034 that you referenced. The general rule is for a 3/4" shank tighten to 150 ft/lbs For a…

Reese shanks do use a 3/4 inch hole to attach a head or in this case a pintle/ball mount. As long as the hole spacing on your PH-4 is 1-1/4 inches apart on center you could use a Reese shank in place of the Convert-A-Ball shank #AMAC1.

The Convert-A-Ball Cushioned Ball Mount, #AMSC4, has two shock absorbers, one in front of the pin hole and one behind the pin hole. This is true for all Convert-A-Ball cushioned ball mounts. Check out the diagram I attached.

Ball mounts like the Curt #C45100 are available in various lengths. This one happens to be 13-inches long, longer than some. Longer ball mounts are needed, for example, in cases of a truck having a slide in camper in the bed, or when using a…

Both the Convert-A-Ball shank, #AMAC1, and Curt shanks have hole spacing of 1-1/4 inches on center so you can use the AMAC1 on a Curt weight distribution system. I have included a link to a video review of the AMAC1 for you.