Review of Equal-i-zer Weight Distribution Hitch - EQ90-02-4900 Video

Thanks for all the detailed information! Given the taller height of your 2019 Chevy Silverado 2500, I recommend the 10" rise or 6" drop Equal-i-zer Weight Dist Shank item #EQ90-02-4900 you were looking at. I strongly agree with you…

The EAZ weight distribution systems are designed to fit the standard shank hole dimensions of 1-1/4 inch between holes that are 3/4 inch in diameter. Most likely your new 2020 Ram 2500 has a 2-1/2 inch hitch size so you'd need a shank like…

What you are most likely experiencing is weld nuts on the vehicle that are packed with corrosion and/or road grime. This happens on any vehicle that has seen at least 1 winter. What you will need to do is clean out the weld nuts so the bolts can be…

Yes the Equal-i-zer weight distribution shank part #EQ90-02-4900 is essentially the exact same shank as the 90-02-4325 you mentioned with exact same dimensions and capacities.

As a rule of thumb for any altitude over 4000ft high, a gas tankless unit will lose 4% of its BTU for every 1,000ft above this height. To troubleshoot this issue you can replace the orifice with a smaller one to keep the oxygen to gas ratio correct…

The Equal-i-zer Weight Dist Shank - 2-1/2" Hitch - 10" Rise/6" Drop - 600 to 1,600 lbs TW #EQ90-02-4900 is a great option for a hitch with a 2-1/2 inch receiver and it will step down to fit the e2 system you have perfectly. This shank…

Yes, the Equalizer Shank part #EQ90-02-4700 that you referenced can be used with other brand weight distribution heads. Basically all of the WD system manufacturers decided to use the same dimensions for their heads and shanks so all of the shanks…

The bolts that hold the head to the shank for the Fastway e2 Weight Distribution w/ 2-Point Sway Control #FA92-00-0600 are 3/4-10 x 5” Grade 5 Bolts. If you're asking about the size of the hitch pin then that would be 5/8". We do have the…

To measure for the correct rise or drop in a weight distribution shank, you want to measure from the top of the trailer hitch receiver to ground (like you did) then measure from the bottom of the coupler of your trailer to ground. If your trailer…

I went out into our warehouse and measured the portion of the Equal-i-zer Weight Dist Shank #EQ90-02-4900 that you referenced and found that it is 2 inches wide and it will work on your Equalizer weight distribution system that you are currently…

For the Equal-i-zer Weight Distribution Shank #EQ90-02-4900 the distance from the top surface of the shank down to the center of the bottom hole is 9-3/4-inches. I verified this measurement with my contact at Equal-i-zer and it is shown on the linked…

The ability to use the etrailer Replacement RV Dinette Tabletop #e97RR is really going to rely on the supports that you use and the amount of weight placed on it. If your legs are collapsible and don't support the table top when in the sleeping…