Bulldog Round Pipe-Mount Swivel Jack Review BD1541150301 Video

The fan of the MaxxAir MaxxFan Trailer Roof Vent w/ 12V Fan - w/ Rain Cover #MA00-06200K draws 5 amps. In theory a 750 amp battery would power this for 150 hours.

There is no bolt-on jack made for a round tube trailer frame since this would make securing the jack rather difficult; it would want to rotate around the frame tube whenever it was under load. You will need to have some steel material welded to…

You are correct that all bolt-on trailer jacks require a square or rectangular frame member for installation. There is no bolt-on jack made for a round tube trailer frame since this would make securing the jack rather difficult; it would want to…

The foot on the inner tube on Pro Series trailer jack #PS1401480303 is attached, all one part, so you would not be able to add a wheel. None of the pipe-mount swivel jacks come with a wheel. Your best option would be to replace the jack with…

If it were my trailer I would fasten the E-Track to the support beams under the trailer, either the side to side one or front to back ones, by going all the way through those support beams. E-Track like #E19148 is zinc-coated steel and since the…

Because the fit to the trailer of a pipe mount jack is a little loose due to the large tolerance between the jack and the pipe mount on the trailer, it's pretty rare to find a pipe mount jack with a removable foot that would allow a caster…

Electric jacks rarely have wheels on them because the wheel capacity is much lower than the jack capacity so it limits them if they have wheels. Instead of installing and removing a jack, I recommend a trailer dolly, #RA20, which is rated for up to…

Easiest way would be to use a strap like a bungee part #EM06701to wrap around the handle and jack body to hold the handle to the jack.

Rack and gear jacks like #BD169201 can get low with a bracket height when retracted of only 8 inches. But rack and gear jacks are low capacity, 750 pounds, and do not swivel. Another low option is Fulton fixed jack #TJ12220301 which can actually…

The overall height of the Round, Pipe Mount Swivel Jack #TJP-5001S-B is 16-3/4 inches when fully retracted and 26-3/4 inches when extended. Basically from the center of the pipe mount to the top of the jack measures 6-1/2 inches.

We have just what you are looking for with the trailer hub part #AKIHUB-545-35-G-EZ-K. This has the correct bearing to fit your spindle and has the 5 on 4-1/2 inch bolt pattern you are looking for as well.

You need to do a little more checking to be sure but I think we have what you need. Check your bearing numbers. If you have #L68149 for your inner and #L44649 for your outer then switching to a 5 on 4-1/2 bolt pattern is no problem at all. If your…