Trailer Wiring Harness Installation - 1999 Ford F-250 Video

Since you're needing everything from the rectangular connector back, we have exactly what you're looking for. You'll need the Tow Ready #118243. Once you unplug the existing gray plug, this connector assembly will take its…

I was able to obtain from Curt a chart showing key dimensions for their 3-Piece Trailer Hitch #C15511 (and other hitch models) that I linked for you. This shows that for hitch #C15511 the overall front-to-back length is just under 24-inches. The…

On a 1999 Ford F-250 with a factory 7-way connector at the rear bumper all you will need to install a brake controller, is the brake controller and the correct brake wiring harness that will connect the brake controller to the factory brake…

The front two mounting bolt holes are 3 inches apart on the Draw-Tite Ultra Frame Trailer Hitch Receiver #41943, and 16-1/4 inches from the front mounting hole to the furthest. The height is 6 inches as well; this is only a fit for 1999-2021 Ford…

The correct quick splice harness needed to install a brake controller in a 20014 Ford F-350 is the part #3035-P. I attached a picture that shows how the connector of it would match what you have in your truck. This could be used as a guide or you can…

It sounds like you are looking for a 7-way solution to install in the bed of your truck because you have an in-bed hitch like a gooseneck or fifth wheel and need a 7-way closer to it. So for that we have the Curt #C56070 which provides exactly that.…

That's a really good question, and the reason the Curt 3-Piece Trailer Hitch Receiver - Multi Fit #C15511 is able to fit both 34 inch and 37-1/2 inch frames on your 1993 Ford is due to the placement of the side plates. If you take a look of the…

The Curt Trailer Hitch Receiver part #13028 could potentially fit your 1966 Chevrolet C10 with aftermarket bumper. However, I would not be able to confirm this as the trailer hitch is only tested with the OEM bumper. I have attached a photo for you…

Because the mounting flange of the Curt #C15511 Class V hitch has 3 tabs on each side, rather than a continuous mounting flange like many other hitches, it'll fit around the rivet shown in your photo. However, be aware that the Curt #C15511 is a…

The 2017 GMC Sierra 3500 cab-and-chassis is a confirmed fit for the Draw-Tite Ultra Frame Trailer Hitch #41947 so long as the truck frame width dimension is 34-inches from outside edge to outside edge. This frame dimension requirement applies to all…

I spoke with my contact at Curt and he put together a chart that has all of the dimensions of the hitches you referenced.

I do have an option for you but I cannot recommend you add any spacers in between the trailer hitch and trailer frame as this would affect the integrity of the trailer hitch. Therefore, if the Curt Trailer Hitch Receiver part #13028 does not clear…