Trailer Hitch Installation - 1978 Chevrolet ck Series Pickup - Draw-Tite Video

The Draw-Tite 75315 hitch has been discontinued, but is only a fit for Ford Full Size Vans. It will not fit a Ford Truck. For your 1968 Ford Truck, I recommend the Draw-Tite Max-E-Loader Trailer Hitch Receiver - Class III #41001 which is a…

Since you have a standard cab and chassis frame dimension on your shuttle bus we have the B and W Hitch part #BWHDRH25122 which will have mounting brackets that are spaced properly. It drops a bit more than 2 inches though. It's actually 5…

A roll pan bumper is a bumper that basically makes the rear bumper look as if it does not stick out further than the rest of the truck and that is molded into the rear of the truck. Its basically a cosmetic modification that you see on a lot of…

We have hitches that fit your 1985 Chevy C10 that has a deep bumper with the Curt hitch part #C13099. Your setup would definitely not be too low to tow with. A rise ball mount would make up for a lower hitch as well. I attached a help article

Sounds like on your taillight assemblies you have the stoplight and running light circuits backwards which is causing the circuits seem backwards in terms of brightness. So what I recommend is you reverse the wiring at the taillight assemblies and…

Thanks for the picture of the rear of your 1972 Chevy C20. Based on that it looks like you would need a hitch for a drop bumper setup like the Draw Tite part #41504 so that it would clear the bumper.

All of the hitches you referenced with the exception of part #13028 have been confirmed to fit your 1992 Chevy Pickup. The rest, part #41524, #75033 , and #75099 have all been confirmed as a fit. The main difference between Draw-Tite trailer hitches…

First, you will need a 4-way connection. The purpose of this connection is to operate your stop, turns, and tail lights of your trailer. The T-One Vehicle Wiring Harness with 4-Pole Flat Trailer Connector #118311 will quickly and easily allow an…

The video for hitch #41001 is on a 1978 Chevy C/K pickup so it does stand to reason that it would be different than your 1986; still amazingly close though. The distance from the bottom of the frame down to the top of the receiver is approximately…

The B&W Trailer Hitch #BWHDRH25122 is a confirmed fit for a 1970 Ford F-250 pickup with a standard or step bumper, regardless of if it is a 4WD or 2WD, and is designed to allow fits for both 34 and 37-1/2 inch frames.

The hitch tube of the Curt Hitch part #13028 is going to be right at 4-1/2 inches below the frame it connects to and the opening would then be right at 7 inches forward of the rear most mounting hole. You'd have to compare that to your vehicle to…