Heavy-Duty Trailer Hitch Installation - 1986 Chevrolet C/K Series Pickup - B&W Video

With you 1954 Ford F100 having a 34 inch frame I recommend the B&W Heavy-Duty trailer hitch #BWHDRH25198. It is a 2 inch receiver and drops down 4 inches from the frame. This would be the pest option that we have.

Maximum amperage draw for 4 Brakes that are 10 or 12 inch diameter is 15.0 to 16.3 amps at 12 to 13 volts. The 14 gauge wire may be sufficient but for maximum braking effectiveness at full load capacity. I would opt to run 10 gauge wire. Larger…

I am unfamiliar with the Barden Bumper and in my research, I could not find any specific information regarding the Barden Bumper. Our trailer hitches are not tested with aftermarket bumpers. We have two bumpers that have been determined to be a fit…

The distance from the bottom of the frame to the top of the 2" receiver of the B&W Heavy-Duty Trailer Hitch Receiver - Custom Fit - Class V - 2" #BWHDRH25198 you were looking at is 7-3/8" as shown in the included…

The Hole spacing for the B&W Heavy-Duty Trailer Hitch Receiver #BWHDRH25198 are as follows(all measurements are for center of hole to center of hole). 34" Width Frame -Front holes- 28-7/8" -Middle and rear holes- 29-1/2"…

It looks like you're asking about the B&W Heavy-Duty Trailer Hitch Receiver, part #BWHDRH25122, for your 1996 Ford F-150. You didn't say exactly which dimensions you're looking for but I went out to the warehouse and measured the…

The B&W Heavy-Duty Trailer Hitch Receiver #BWHDRH25122 that will fit your 1986 Chevy K20 will measure 5.438" from the top of the frame brackets to the top of the receiver. If this is looking like it will not be enough to clear the bottom of…

I was not able to locate an exact towing capacity for your 1992 Chevrolet C2500. However, if you take a look at your driver door jamb for a white sticker it should list both a gross vehicle weight rating (GVWR) and a gross combined weight rating…

Sounds like you have a deep drop bumper on your 1997 Ford F-350. The B and W hitch part #BWHDRH25198 is designed to fit that specifically so it would fit and work well. I attached an install video for you to check out as well.

Sway control is beneficial in towing conditions such as crosswinds or a large truck passing; the system will allow you to have greater stability and control than otherwise. There is a sway control bar that could work for you, the Reese Friction Sway…

Both the Draw-Tite Ultra Frame Trailer Hitch Receiver #41947 and Draw-Tite Ultra Frame Trailer Hitch Receiver #41938 are a confirmed fit for you 1969 Chevrolet K10 as long as you have an 8 Foot bed and both options will require some drilling for the…

I spoke with my contact at Curt about trailer hitch #C15445. He said that from the rear most attachment points on the vehicle to the top of the cross tube is 5-1/2 inches. If this is not a great enough distance to accommodate the step bumper and ramp…