Trailer Hitch Installation - 1986 Chevrolet C/K Series Pickup - B&W Video

The Underbed Toolbox Mount Kit #350998 measures 18" long which is going to be the standard length for these types of brackets. The closest we carry to the 25" long bracket you're looking for would be Mounting Brackets for Buyers…

The Hole spacing for the B&W Heavy-Duty Trailer Hitch Receiver #BWHDRH25198 are as follows(all measurements are for center of hole to center of hole). 34" Width Frame -Front holes- 28-7/8" -Middle and rear holes- 29-1/2"…

I have attached a photo of the B&W Heavy-Duty Trailer Hitch Receiver, part #BWHDRH25198 you asked about. I have noted the mounting holes on the photo you can check out. The distance center-to-center from the front mounting hole to the second is…

I spoke with my contact at Curt to obtain the mounting bolt hole locations for the Trailer Hitch Receiver, #C15300 on a 1993 Ford F-150. I have attached a picture to illustrate these measurements. As for repositioning the spare tire, you may need to…

For your 1995 Chevy C3500, I recommend your start with the Tekonsha Prodigy P3 brake controller #90195. This proportional controller will apply your trailer brakes at the same time and with the same intensity as you hit the brake pedal in your truck.…

The horizontal mounting plate that mounts to the frame of your vehicle on the #41947 is 2-13/16" wide and the mounting plates themselves are 11-9/16" tall. The holes on the horizontal mounting plates are 3/4" and 1-1/4" in…

I am unfamiliar with the Barden Bumper and in my research, I could not find any specific information regarding the Barden Bumper. Our trailer hitches are not tested with aftermarket bumpers. We have two bumpers that have been determined to be a fit…

Since you found low voltage when testing the right side signal light pin on the vehicle connector, you have at least isolated the issue to the truck. If all the wires appear to be in good condition, then the issue is likely either a weak ground like…

For your 1987 Chevrolet C/K Series Pickup the B and W hitch part #BWHDRH25198 that you referenced would work really great if you had a deep drop bumper but if instead you had a standard bumper you'd want the standard version of this hitch…

I would be happy to help you with dimensions to the Buyers Products 2" Hitch Receiver For GM Express/Savana with Cutaway Chassis item #3371801102 you were looking at. The measurement you are asking about is 9-1/2". This is from the top of…

For your 1980 Chevy truck with a short bed and a standard bumper the Curt hitch part #C14082 is a confirmed fit and would work well. Curt has confirmed the fit for us.

I spoke to my contact at Curt about the Curt Trailer Hitch Receiver part #C14082 for your 1986 Chevrolet C/K Series Pickup and they informed me that as long as the spare tire is of the stock tire size then it will work with the hitch installed. If…