Solera Slider Slide-Topper Installation - 2015 K-Z Durango Fifth Wheel Video

The Air Lift LoadLifter 7500 XL Air Helper Springs part #AL57589 are designed to be used in conjunction with a coil spring rear suspension. The air bags do not replace these but rather work alongside them. The air bags also do not work with models…

When choosing the slider you want to measure the outside front of box width including the flange. Then you need to select a slider that extends a minimum of 2-1/2 inches beyond each side of the box width. For example, the Black Solera Slider…

Yes; when using a weight distribution hitch while towing with your 2019 Ford F-150, using the Timbren Rear Suspension Enhancement System #TFR1504E will help with stability. The weight distribution will help with leveling, but the Timbrens are going…

For sag from towing a trailer the best recommendation I can make is actually a weight distribution system. Suspension enhancement will help level your truck while towing. But the advantage to a weight distribution system is that it levels the vehicle…

When installing/adjusting the Solera RV Slide-Out Awning #LCV000163285 tension is applied by rotating the awning roller 14 times. This should apply the needed spring tension so that the fabric doesn't billow in the wind or leave enough slack that…

With the lack of clearance your options are more limited but you can still get a slide topper for your slide out. You will just have to realize you may not have full coverage of the slide out. You can down size to a smaller slide out topper that…

To adjust the tension on your Solera RV Slide-Out Awning, #LCV000163285, you'll want to remove the slide topper from the brackets and reroll the awning roller 14 times to add enough tension to the springs. You'll also want to ensure your end…

Put the pin back in and wind it 12-16 times rolling it towards the camper to put the correct tension in the slide topper #LCV000163285 before installing it. This will give you the correct amount of tension for extending and retracting the awning.

Thank you for the photo, and I can tell you that the Solera RV Slide-Out Awning - 11'1" Wide #LCV000184673 does require at least 7 inches of clearance in order to install. Unfortunately, there is just no way to shorten the awning, so the…

The awning arms are measured from top to bottom of the wall mount. This can then be used to select the correct length replacement. I have attached a photo below to assist. You will also need to pay attention to the style of arms such as pitched or…

For a 96.5" flange measurement you'd need the Solera RV Slide-Out Awning #LCV000168107 or #LCV000163289. This will overhang roughly 3-4" on each side of your slide out so you'll want to ensure there isn't anything in the way…

Since you have 6-1/2 inches of clearance from the slide out flange to the awning rail that you mentioned the Solera Slide Topper #LCV000182037 will fit and work great. We've asked Solera about this in the past and they've said that the…