Review of etrailer by AxleTek Trailer Axles - 72 Inch Long Trailer Axle with Idler Hubs - e32GR Video

It is possible to replace your 62" long axle with a longer one. Our next size up is going to be a 72" long 2K rated axle like part #e32GR. The axle being 72" across measured from hub-face to hub-face. This axle comes with 5…

The 3 inch shackle bolt part #166081 would be a great option to use with the CE Smith suspension hanger part #CE14016G. This would be a better fitting size than going with the longer 3.5 inch bolt you mentioned.

I completely understand your troubles and confusion with leaf springs. First do remember there are different types of spring steels so the thickness of the leaves is not always the best way to judge the weight capacity for the leaf springs. So…

It could just be the angle but looking at the picture you attached it appears that you have a 1-3/4 inch diameter axle. This would be consistent too with the smaller 2,000 pound axles that are typically on jet ski trailers like what you have. I do…

The Timbren Axle-Less Trailer Suspension System #A35RS545 is the only thing we offer that would fit your narrow Harbor Freight trailer. Our shortest 3,500lb standard Axle #e65GR is 89" wide from hub face to hub face. The Timbren system above…

It sounds like you may instead have 7,000lb axles on your two axle dump trailer with a weight like 14,000lbs. I wasn't able to find any information off the numbers you provided. The best thing to do is to take off your hub and find the bearing…

Yes the slipper spring part #e29SR that you referenced can install below the trailer axle. I attached a picture that shows it installed in this orientation.

The etrailer Axle #e32GR uses a Easy Grease Trailer Idler Hub Assembly #AKIHUB-545-2-EZ-2K which will use the Bearing Kit #BK1-150. I do recommend pulling one of your hubs apart to verify that the bearings and seals match the spindle on your axle.…

Yes, you can replace a trailer's round axle with a square axle as long as the weight capacity is appropriate. You will need a new U-bolt kit to connect the axle: 1-1/2 inch square axles #CE23102 1-3/4 inch square axles #175130 for the U-Bolts and…

Yes, you can replace a square axle with a round beam axle so long as it is rated appropriately. You will need a new u-bolt kit for the round 2K axle, part #APUBR-10. We offer beam axles rated up to 3500-lbs and also axle-less suspension kits from…

In order to find the correct replacement axle for a trailer you'll need to first note the capacity which can be found on the axle tag sticker located in the center of the beam. Then you'll need to measure the length, both hub face and spring…

Actually the overall diameter/height of those tires are different by a few inches. The overall diameter of a 4.80/4.00-8 tire is 16.1 inches. The overall diameter of the 5.70-8 tire is 18.1 inches. The outer diameter of the #AM10002 tire you were…