etrailer Trailer Hubs and Drums - Hub with Integrated Drum - AKHD-655-35-K Review Video

Thanks for the Picture. What you have there is a 6 on 5-1/2" hub for a 3,500 lb axle. We do have a replacement hub for your Truryde RVD-H-65535 hub. The correct replacement will be part #AKHD-655-35-EZ-K. This will include the hub, bearings,…

We have it, the etrailer Hub and Drum #AKHD-655-35-EZ-K, listed out for a 3,500 lb axle (and we break the math down on the product page) but when it comes to the hub side of things it's more about making sure it physically fits so since the…

For a 12,000 lb. electric car trailer winch like the Bulldog Winch Trailer Winch part #BDW10040, I recommend a standard 12 volt lead acid battery rated up to at least 650 cold cranking amps (CCA). As long as the battery is rated up to 650 CCA then…

The TruRyde Spindle Nut #165686 has an outer measurement of 1.45 inches. You will use a 1-1/2 inch socket on this castle nut or we usually use a channel lock for these installations. I've attached a video of an installation of a hub to assist.…

If you have a trailer wheel that has a 6 lug setup you are going to have a bolt pattern of 6 on 5-1/2 inches. This is the standard 6 lug wheel bolt pattern that trailer rims have. If you are unsure you can check out the help article I attached that…

The hub you describe is a 3500 lb 10 inch hub/drum with a 6 on 5-1/2 inch bolt pattern which uses an L44649 outer and an L68149 inner wheel bearing and a 58846 grease seal. For a replacement, I'd recommend the #AKHD-655-35-EZ-K hub/drum. The…

Assuming you are looking for a 2,200 lb axle you can use the Trailer Axle with Idler Hubs - 5 on 4-1/2 Bolt Pattern - 60" Long - 2,200 lbs #e94YR. If you do not need the hubs then we also have the Trailer Idler Axle Beam with Easy Grease…

The Dexter Hydraulic Trailer Brake Kit #23-342-343 is the correct kit for you. This hydraulic drum brake assembly is designed for use with your surge-type trailer brake actuator. The brake's free-backing design lets you reverse without trailer…

To replace a spindle, the old one would need to be cut off, and the new one welded into place. This is NOT a job for the do-it-yourselfer. The new spindle must be absolutely square with the axle in order to prevent premature tire wear and wheel…

The #QT655 hub cover is 3-3/4 inches deep, from the surface that touches the wheel to the end of the inside face of the cap. An EZ Lube grease cap typically isn't much larger than a standard so it should work just fine.

Since your trailer has a 3,500 lb axle on it currently the hub part #AKHD-655-35-K that you referenced will be what you'd need to go to a 6 on 5-1/2 inch bolt pattern.

Karrier and Loadstar are two different brand names used by Kenda. There's no difference in quality or function between the two brand names. For a ST175/80-13 Radial trailer tire in load range D, I'd recommend part #AM10210 if you're…