Review of Tow Ready Hitch Ball - Trailer Hitch Ball - 63845 Video

For a ball mount that will give you the proper rise or drop use the Flint Hill Goods Adjustable Steel Ball Mount Kit w 2 Hitch Balls #FHG79ZR. U-Haul trailers have a standard coupler height of 18 inches so this adjustable ball mount will allow you to…

Yes, the Curt ball mount part #D-28 is made in the USA. The part #C45070 is a very similar ball mount that is much shorter but has same rise/drop.

The T-One Vehicle Wiring Harness with Upgraded Circuit Protected ModuLite HD Module #118781 is confirmed to fit your 2023 Honda Odyssey and will provide you with the 4-way connector that you are needing. The powered ModuLite reduces the strain on…

Yes, the Hidden Hitch part #87488 that you referenced has been confirmed as a fit for your 2016 Toyota Sequoia so I would recommend it for you. If you wanted to do some towing you might be interested in etrailer ball mount kit #989900. It comes with…

According to the review video we have of the Brophy #RTB1 ball platform those holes used to vertically adjust this piece are 2" apart on center. It kind of sounds like you have a shank for a weight distribution system as the 1-1/4" height…

I went out to the warehouse to measure the Curt ball mount #D-28 for you. From the center of the pin hole to the closest end of the shank it is 2-1/2 inches. From the center of where the rise begins is it is 8-1/4 inches. Also, the distance from the…

The bolts for the Curt Trailer Hitch Receiver #C13240 are M10-1.25 x 30 inch hex bolts, and they are already threaded. I have added links below for you to check out of the instructions and a video install on a 2020 Hyundai Tucson of the Curt Trailer…

Thank you for clearly explaining your intended use for the ramps you want for your 10K tandem torsion axle trailer. The highest-rated ramps we offer have a 6000-lb capacity. All are shown on the linked page. These vary in width, length and lift.…

In order to get a ball mount that has effectively 0 inches of rise or drop you would need to get a Trailer Hitch Ball Mount, part #D-4, like the one you referenced that has a 2 inch drop, and then use a 2 Inch High Rise Ball, part #C40034. I attached…

We don't have a wider bracket than the #RP26005 for your ball mount so the best option we would have would be a new ball mount that has the bracket already attached like the Curt #D320 which has a drop of 2 inches since you aren't wanting to…

The Lionshead Trailer Wheel Center Cap w/ Snap-In Plug part #LHCS102-SI60C is 3.5" deep. This can then be used to determine compatibility with a buddy bearing.

Without know exactly which center cap you already have, I would recommend purchasing a whole new plug and cap. Each plug has a specific wheel cap it will fit. I recommend The Lionshead Trailer Wheel Center Cap w/ Snap-In Plug - 3.19 inch Pilot -…