Distance from Pin Hole to The End of Curt Ball Mount # D-28
Question:
Could you tell me the measurement from the end of the shank to the center of the hole where pin goes in? Also the hole to the place where the actual mount starts.
asked by: Al
0
Expert Reply:
I went out to the warehouse to measure the Curt ball mount # D-28 for you. From the center of the pin hole to the closest end of the shank it is 2-1/2 inches. From the center of where the rise begins is it is 8-1/4 inches. Also, the distance from the center of the hole to the center of the hole where the ball mounts is 14-1/4". You can see this measured in the attached video.
expert reply by:
Michael H
0
Product Page this Question was Asked From
Curt Ball Mount for 2" Hitches - 4" Rise, 6" Drop - 14-1/4" Long - 6,000 lbs
- Trailer Hitch Ball Mount
- Fixed Ball Mount
- No Ball
- 1 Inch Ball Hole Diameter
- Steel Shank - Gloss Black
- Drop - 6 Inch
- Rise - 4 Inch
- Fits 2 Inch Hitch
- 6000 lbs GTW
- Class III
- Long Shank
- CURT
more information >
Continue Researching
- Article: How to Measure for Trailer Hitch Drop
- Q&A: Recommended Hitch for a 2014 Dodge Grand Caravan
- Article: Ball Mount Basics: Weight Capacity, Class, and Size
- Q&A: Does Curt Heavy Duty Forged Ball Mount Have a Solid Shank
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Q&A: What is the Ideal Height for a Ball When Towing a U-Haul Trailer?
- Q&A: Is Underbody Panel Re-Installed After Mounting etrailer.com Hitch # E98853 on 2011 Toyota Sienna
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Q&A: Hidden Trailer Hitch Recommendation for 2012 Toyota Sienna
- Article: Trailer Hitch Receiver Sizes
- Q&A: Recommended Torque for Tightening Curt Hitch Balls to Ball Mount
- Q&A: What is the Difference Between a Class II and a Class III Hitch?
- Article: How to Choose the Right Trailer Hitch Class
- Article: The 5 Best Trailer Drop Hitches You Can Buy