Tow Ready 2 Inch Long Shank Hitch Ball Review Video

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

We first need to know what size is required for your camper when closed up. When measuring for a pop-up trailer cover you want to measure from the back of the camper to the front of the trailer box when it is closed up. This is to include any storage…

Yes, we do carry multiple hitches, ball mounts, that are similar to the Convert-A-Ball Ball Mount for 2" Hitches item #AMSC12 you were looking at. The closest comparable product would be the Brophy Trailer Hitch Ball Mount 10" Drop, 7,500…

The stop light switch circuit on a 2019 Toyota Highlander which will be needed to install a brake controller like the Tekonsha Prodigy P3 Trailer Brake Controller part #90195 can be found by testing the bundle of wires attached to the brake pedal.…

The ideal height will actually have to do with how tall the coupler of the trailer is from the ground. The Draw-Tite #76020 will sit at 13 1/2 inches from the ground to the top of the hitch when installed on a 2016 Mazda CX-9. From what I could find…

The Curt ball mount #C45042 only comes with the ball torqued into the drop position but we do have part #C45155. This has the ball in the rise position and it's a 2-1/4 inch rise but it's only a 2 inch ball not a 2-5/16 inch. If you need a…

To tow a smaller trailer with the 2015 Honda Odyssey you will need a hitch, lock, ball mount, ball and wiring. If the trailer has electric brakes, you will also need a 7-Way plug on the vehicle and a brake controller. I recommend to use the Draw-Tite…

Tire designations ST205/75D14 and ST205/75R14 are both for special trailer tires with a 205mm width, 75-percent aspect ratio and that fit a 14-inch wheel. The difference between them is the tire's type of construction. The ST205/75D14 tire is a…

To help alleviate the back and forth chucking you are experiencing with your 2 inch receiver there are a couple of things I recommend doing. First is to use a cushioned ball mount, the Convert-A-Ball, which is designed to reduce this type of movement…

You will need a 5/8" diameter pin such as #37201074. This fits 2"x2" trailer hitch receivers and has a usable length of 2-7/8".

Yes, the Curt ball mount part #D-28 is made in the USA. The part #C45070 is a very similar ball mount that is much shorter but has same rise/drop.

We don't have a combo of the Curt Hitch Ball #C40008 and Curt Ball Mount #C45340. The ball mount is extremely heavy-duty, rated up to 17,000 pounds. I think it's safe to assume you don't have a torque wrench rated up to 450 foot pounds…