Review of Timbren Vehicle Suspension - Rear Axle Suspension Enhancement System - TFRTT350E Video

There are air bags that will fit your 1996 Ford F-350 2-wheel drive dually but #F2550 is not one of the options. The options that are available will not work with the B&W gooseneck hitch installed but I do have a solution for you that will…

The higher capacity Timbren kit part #TFR350SDE will fit a 2001 Ford F-250 or F-350 so it would work well for you. It has a higher capacity at 8,600 lbs compared to the #TFR250SDE which is rated for 6,000 lbs. Since you have the F-350 springs…

The Timbren Suspension Enhancement System #TFRTT350J would be my recommendation. These are designed to improve handling and safety by becoming more rigid with weight added. This will help increase stability, reduce the sag you mentioned, and each…

The SuperSprings #SSA22 would be a smart choice to raise your 2012 Ford F-250 when pulling your fifth wheel. They are designed to prevent the sagging you are experiencing and should put you pretty close to level. If you take a look at the attached…

For your 2016 Ford F-350 Diesel carrying a 1800lb truck bed camper and towing a 20' boat the correct SumoSprings would be the #SS84VR if your truck is 4WD or the #SSR-114-54 if your truck is 2WD. You will not need to add the springs to the front…

Since the air spring kits that fit your 2003 Ford F-350 fit above the leaf springs the Timbren kit part #TFR350SDE would fit with them since they sit to the inside of this area on the axle. If you are maxing out your air bags and want additional…

The correct Timbren kit you'd need for your 2003 Ford F-350 Crew Cab with factory overload springs is the kit part #TFR350SDE which fits with or without overload springs.

From the looks of the photo you have attached it appears you have a lower overload spring, not an upper overload spring that is required for the TorkLift StableLoad Suspension Upgrade for Upper Overload Springs part #TLA7200 to work. This kit will…

I checked with Torklift and the TorkLift StableLoad Suspension Upgrade for Upper Overload Springs part #TLA7200 which is a fit for a 2008 Ford F-150 features a no-drill application but does require the factory installed upper overload. I have…

The product picture for the #SSC2412CAGY is a typical photo. Since we do not have a picture (yet) of this product installed in a truck like yours we instead use a product picture that shows a similar set of seat covers installed in a similar truck…

The weight is pretty similar between the aluminum Torklift camper tie downs part #TLF2022A and the steel part #TLF2022 which is 4 lbs heavier at 39 lbs vs 43 lbs.

Of the two part numbers you mentioned only the #TLF2022A is a fit for your 2022 Ford F-350 short bed without factory board and with the factory installed hitch. You might have meant to type #TLF2022 which is the non-aluminum/stainless steel option…