Redline Tie Down Anchors WLS100 Review Video

The 1" Long Black Torx Wall Liner Screw #WLS100 is the best option for the plywood installation. These screws are fine thread and made for metal studs. They have a tapping edge but often a starter or pilot hole should be drilled. You can then…

Here the e-track and e-track accessories you are going to want to accomplish what you are looking to do. We offer the e-track in 5 foot sections like #E19148 which you'd need to install where needed on your trailer, we have the e-track motorcycle…

Yes, the Erickson Horizontal E-Track part #E19148 will be plenty strong enough to secure your two rock crawler buggies. The tracks are each rated at 6,000 lbs max break strength and 2,000 working load limit. I assume you would have a track under each…

Thanks for the photo of your trailer interior. E-Tracks like #E19148 need to be mounted with at least 2 fasteners per linear foot on each side to a structural surface on the trailer in order for them to meet their specs. I see from your photo that…

Yes, you can use Erickson Horizontal E-Track item #E19148 as front straps to hold down a car. These tracks have a 2,000 lbs maximum capacity per track. You will want to use the etrailer E-Track Backing Plates w/ Hardware item #e96RR for mounting. The…

E track like the part #E19148 (5 foot section) would work well for what you are looking to do. People use E track for car haulers all the time and it works well. We even have a wheel strap designed for E tracks, part #EM58523 which will work great.

The Erickson Horizontal E-Track, part #E19148 has 1/4 inch diameter mounting holes spaced 2 inches apart. The screws you use should be at least long enough to go 3/4 inch into the wood you are mounting the track to. The more screws you use the more…

The RC Manufacturing T-Series Trailer Tongue Toolbox - A-Frame - Steel #313-TM362016M is just the steel box. Most people drill into the bottom of the box to hold the box to the trailer frame with self-tapping screws like #WLS100. You can weld it if…

7-ways have the brake controller output circuit on them for activating the trailer brakes but if your vehicle does not have one installed it would not be able to control them until you did. For a brake controller I would recommend the Prodigy P3…

The material that is on the ramps of your 2007 Sundowner horse trailer is a type of artificial carpet that is typically pretty easy to install and inexpensive to replace if you stick with the carpet. Usually that type of carpet will be glued and…

There is no mounting hardware included with the Aluminum A-Frame Trailer Tongue Toolbox, item #350970, due to the different construction and mounting locations that may be required for many different styles of trailers. I would recommend using a…

The Trailer Horse Pad Screw #PS-8 are the screws you will need to attach the rubber pad on your 1999 Sundowner ramp. The screw is #8 X 3/4 inch screw.