Malone Hitch Anti-Rattle - Standard Anti-Rattle - MPG908 Review Video

The curve in the Malone Anti-Rattle HitchLock System part #MPG908 is designed for extra stability to not allow the shank of the accessory to move up and down. It is what holds the shank of accessory tight. I have attached a photo of how this is…

We have just what you're looking for with the Gen-Y Anti-Rattle Clamp for 2" Hitch Receivers #GY88XR. The sleeve acts as a wedge to take out play between your hitch receiver and extender. Although it does not not require a wrench and a…

Since the 1,200 Equal-i-Zer spring bars #EQ90-01-1299 are wider at 1-1/2 inches than the 1,000 lb bars which are 1-3/8 inch you'd have to swap heads too. So with that you'd need the part #EQ90-02-1200 too to be able to convert from 1,000 lb…

We do have the Equal-i-zer 1,200 lb tongue weight spring bars with the part #EQ90-01-1299 which it sounds like you are in need of. You should note that you'll have to replace the head of the system too since they are all different sizes based on…

Weight distribution spring bar tension can be increased by tilting the head toward the trailer so that the ends of the spring bars are closer to the ground. Once connected to the lift brackets this increased angle translates into more tension, which…

We do have other anti rattle devices that we carry, but nothing specifically designed to limit fore/aft movement. If you have already tried The Blue Ox immobilizer #BX88312, I'm afraid I do not have a more effective anti rattle device that I can…

You will use metal screws to install the etrailer Horizontal E-Track #e42VR. You'll also need backing plates to install this e-track and the mounting hardware is actually included with the etrailer E-Track Backing Plates with Hardware #e76YR. The…

There really isn't a profile difference between the tapered style of Tow Rax L-Track like the part #TWSP12TAB and the low profile #TWSP72TA. The low profile does sit a little taller at 1/2 inch tall whereas the tapered is 7/16 inch. That's a…

The Curt Trailer Hitch Receiver #13018 has the mounting bolt holes spread 3-1/4" horizontally by 2-1/4" vertically. These measurements are from center of hole to center of hole.

You'll need a new setup when going to a different spring bar since the bars would be rated totally differently. The part #EQ90-01-1299 is the correct spring bars and then for the head you'd want #EQ90-02-1200.

Yes. You absolutely, positively, without any shadow of a doubt MUST use Swagman Bike Frame Adapter Bar #64005 with your Trek Marlin 6 & 7 bikes on either the Yakima LongHaul #Y02476 or Thule Range #TH9057. As for the racks themselves, I would go…

To upgrade to a higher spring bar rating with an Equal-i-Zer system you have to replace the bars and the head since the bars are all different sizes and the heads are made to fit them specifically. So for bars you'd need the part #EQ90-01-1299…