Review of Lippert Components PSX2 Stabilizer Motor and Gear Box - LC759091 Video

You made a great choice in the Lippert Components Power Stabilizer Trailer Jack. For starters, all of the jacks measure to be 70-1/2" long with a 3,500 lb weight capacity and have a 30" lift. The difference between them is in regards to…

The replaceable parts for the Lippert PSX2 stabilizers include the following: Switch and Harness - #LC387874 Switch Hatch Box (White) - #LC134025 If you're needing to replace the entire unit we don't have the PSX2 but we do have the Lippert…

First you will want to use a Test Light #PTW2993 to verify if you are getting power to the switch on your stabilizer. There will be 4 wires to the Switch #LC387874. The 2 wires going away from the stabilizer are going to be the power and ground…

I apologize for any confusion on what the proper torque specs are for 1/2 inch lug nuts on trailer wheels. I attached a picture of a chart to the right that details what the proper torque specs are for a trailer wheels lugs based on lug size, wheel…

The Lippert Ground Control 3.0, 4-Point #LC358590 OR 6-Point #LC675817, comes with a 1-year limited warranty.

Yes, the motor for the Lippert Components PSX2 Electric RV Stabilizer can be replaced without obtaining an entire new system. The Replacement Motor and Gear Box Assembly for Lippert Components PSX2 Electric RV Stabilizers part #LC759091 is what you…

There is usually an in-line fuse with wiring that leads up to the battery. The best thing to do first is to disconnect the system from your battery for about 10 minutes and then reconnect. This will serve the same function as a reset button. If this…

I do have a solution for you even though Lippert does not offer a replacement power cord/boot for your Lippert PSX2 Stabilizer Motor #LC759091. First we'll start with the wires running to your trailer's battery. Strip back the black casing…

Sounds like the one side of the stabilizer is in need of a replacement motor. Which for that we have the motor part #LC352338 since you said you have a Lippert stabilizer jack setup. If you are unsure if this is the correct motor email me back with…

For a replacement motor for your powered stabilizer jack #LC369774 you will need Klauber motor part #LC352338.

I contacted Lippert and they do not sell the rubber cover for the motor of the stabilizer jack part #LC298707. The only real way to replace it is to replace the motor with Replacement Electric RV Stabilizer Jack Motor for Lippert Components Landing…

Yes, the Universal MightyMounts for Yakima Roof Mounted Accessories part #Y03590 will allow you to mount your Yakima HullyRollers and Yakima Mako Saddles on aero crossbars.