Review of JR Products Hitch Pins and Clips - Snapper Pin - 37201051 Video

I would use a protractor, see photo, place the protractor on the edge of the inside of one side of the trailer frame and the other inside edge of the trailer frame should be parallel with the 50 degree line on the protractor. Another way to verify…

We currently have three versions of the Demco 32 degree A-Frame coupler but none of them are zinc plated. We have the part #DM15633-97 which is primered, the part #DM15633-81 which is powder coated black, and we have the part #DM15633-52 which is…

The only differences between the Demco eZ-Latch Couplers #DM37ZR and #DM14793-81 is that the former has integrated loop holes for installing safety chains and a about a 2" drop while the latter doesn't come with provisions for…

To install the Demco A-Frame Trailer Coupler #DM16680-52 that you referenced, you will want to use 3/8 inch, grade 5 bolts , approximately 1-1/2 inches long (depending on how you are installing the coupler). You will want to use 5 of these bolts…

Hi Larry, So we have a couple bumpers that may work, though each is 96 inches long. They can be cut to length though, and the difference is their width, as one is 3" wide and the other 4" wide to fit different size bumpers: -…

The play you are feeling/hearing is most likely between the hitch ball and the latch of the coupler. If you look under the coupler you can see an adjustment bolt that uses an Allen wrench that will allow you to tighten the latch and get rid of the…

Yes, you can remove your weld-on coupler and install a new bolt-on coupler that fits a 2 inch ball. There is just a few things you need to do to before and when installing. You need to know what channel size and the weight capacity you will need…

We don't have an option that will allow for all of them to be keyed alike but I can get you down to one key for the hasp locks and another for the coupler lock. The Trimax Puck Locks for Trailer Door Hasps #TMX73FR comes with three…

Hey Pete, so the part #DM16680-52 has a much higher capacity at 21k whereas the part #DM14793-81 has a 10k capacity.

Thank you for the image. It appears you will need either the Demco Channel Tongue Trailer Coupler #DM13203-95 or #DM16080-95. Both of these couplers have a zinc coating for increased corrosion resistance and fit on a standard 3" wide…