Customers compare HM20048 to these similar products
Products Featured in this Video
Today we're gonna review part number HM20048. This is a Hopkins 7-way molded trailer wire connector. This is 11 feat long of cable. Now, this is a 7-way trailer end connector which allows you to replace the damaged inaudible 00:00:15 on your trailer. It's pre-wired to easy installation. It's molded.… see more >
Info for this part was:
At etrailer.com we provide the best information available about the products we sell. We take the quality of our information seriously so that you can get the right part the first time. Let us know if anything is missing or if you have any questions.
Videos
Help Articles
Expert Answers
For your 2016 Mercedes-Benz Sprinter 2500 you can use the Universal Installation Kit for Trailer Brake Controller #ETBC7 for a 7 way kit. This kit will utilize an existing 4 pole connector, so if you don't have one you can add one with…
view full answer...The SumoSprings kit #TSS-106-40 does for sure fit your application based on the dimension you just mentioned of 7-3/4 inches from the spring plate to the bottom of the trailer frame. This kit works with dimensions here that range from 6 to 8-5/8…
view full answer...The Timbren kit part #TTRA1702 is 2-3/4 inches tall and would work great for you to give you additional support. This will provide up to 1,000 lb of additional support.
view full answer...Yes, the Reflex Reflector Flange Cover part #A211RXB that you referenced does fit the GloLight LED trailer tail light part #STL1211RCFHPG that you also mentioned.
view full answer...The most likely cause for the incorrect behavior of your trailer lights, where activating one turn signal causes all trailer lights to blink, is an insufficient ground (or a short to ground) on either the vehicle or the trailer. Since you re-wired…
view full answer...We do have a converter that will let you convert the combined brake and turn signals from your Honda without splicing into the vehicle wiring. The wiring would be done on your trailer. I recommend part #118158. You would cut the harness on your…
view full answer...When we installed the SumoSprings Solo Custom Helper Springs #SSR-307-47 on a 2013 Ram 1500 we did not use the included spacer. There are really 2 factors that are going to come into play when deciding if you will need the spacer on your 2016 Ram…
view full answer...The height of the SumoSprings Trailer Helper Springs w/ Line Relocation Bracket #TSS-106-40 is 4 inches for just the rubber spring portion of it. Since you have 3 inches from the axle to the frame that would indicate that there would be a compression…
view full answer...The U-bolts of the U-Bolt Kit part #APUBR-1 are Grade 5. I attached an install and review video for this kit for you to check out as well.
view full answer...It's not possible to look up which particular taillight lens your Forest River Flagstaff Super Lite uses, as there isn't a database of that information, but we very well might have a solution for you. From what I found online, the Optronics…
view full answer...Based on the measurements you have given, the correct kit would be the #K71-657-00 Dexter E-Z Flex Suspension Kit - Double-Eye Springs - Triple Axle - 8,000 lbs. You want to use the short equalizers. The hangers you have are designed for the…
view full answer...I went to the warehouse and took some measurements of the Brophy Banjo Eye, part #BE31 and part #BE38. I have attached a photo of the Banjo Eye with the dimensions noted. Both of these measures 3-1/2 x 3-5/8 inches and the material is .310 inches…
view full answer...