Review of HappiJac Manual-to-Electric Truck Camper Jacks Conversion Kit - LC733960-182524 Video

Based on the Happijac setup you have the correct electric upgrade kit you'd need is the #LC733960-182524.

The Manual-to-Electric Conversion Kit for HappiJac Truck Camper Jack Systems Item #LC733960-182524 has everything you need to convert to electric jacks and will not require any special tools to install.

It looks like your model 7345 is rated for 45 amps and the only options we have for you to add a lithium battery charger is by using the Progressive Dynamics 9300 Series RV Converter Charger #PD69RR or the whole 4000 Series Mini RV Power Center…

The Parallax 7345 has a 45 amp converter in it so the Progressive Dynamics Mighty Mini AC/DC Panel and Converter/Smart Charger - 45 Amp #PD4045KA you were looking at would be a perfect replacement for it. They'll just need to flip the small…

Yes, the Replacement Jack for HappiJac Truck Camper Jack System part #LC736514 (Model 4220) will fit your HappiJac Truck Camper Jack System Model 4150. If you need a new gearbox/motor then we have that as well, the Replacement Motor and Gear Head…

You will most likely need the Replacement Motor Heads w Circuit Board and Remote #LC733960. These are a direct fit for 4150, 4220 and 4820 series jacks. As you mentioned you already have the Wiring #LC182524 you will not need the full…

The support braces in the HappiJac Truck-Mounted Camper Tie-Downs #LC182860 are going to attach to the cross frame to provide support for the anchors which will bolt through the bed wall and into the braces. The rear anchors will bolt through the…

To convert your Happijac 4150 series camper jack to electric from manual the correct kit you need is the part #LC733960-182524 that you referenced. This for sure is the correct kit as we have verified it with Happijac.

The HappiJac 4200 are the manual jacks. We do have the upgrade kits available. The Replacement Motor Heads w Circuit Board and Remote for HappiJac Electric Truck Camper Jack Systems #LC733960 are compatible with the 4200 series if you are replacing…

To start, if you don't already have a Torklift dual hitch like the #TLF1000 on your 1988 Ford F-350 you will need to install one. This will allow you to use the TorkLift SuperTruss Hitch Extension for SuperHitch Trailer Hitch Receivers - 48"…

The Curt Trailer Hitch Receiver - Custom Fit - Class V XD - 2" #C15409 is designed to fit below the factory hitch receiver on your 2008 Ram 3500 dually. The top of the Curt receiver will be 8-1/2 inches from the bottom of the frame where it…

The overall length of the side plate that attaches to the frame on the TorkLift SuperHitch Original Trailer Hitch Receiver #TLF1000 referenced in your question is 22-1/2 inches. The trailer hitch has 6 holes on each side (12 total) and each hole is…