Review of HappiJac Camper Tie-Downs - LC182894 Video

The HappiJac Qwik-Load Upgrade Kit for Standard Turnbuckles part #LC182894 is an excellent upgrade option for the HappiJac Original Turnbuckles for Camper Tie-Downs part #LC182898. These are going to cut down dramatically on the time it takes to…

The barrel on the Replacement Front Turnbuckle for HappiJac Original Turnbuckle Set, part #LC182901, is 10 1/8" in length. I have included a product description, a video review link below.

According to HappiJack, their turnbuckles that the #LC182894 are meant to be used with do not carry a weight rating or a capacity. When the turnbuckles are installed properly, they are designed to have sufficient capacity to handle the weight of any…

The equalizers in the kits #K71-652-00 and #K71-654-00 that you referenced are actually the exact same. The only difference between these kits is that the 652 comes with replacement shackle straps while the 654 only comes with the equalizers and no…

I spoke to my contact at Brophy and he informed me that the diameter of the pole that would fit the Replacement Tripod part #1003 that you referenced will be 1-1/2 inches.

I measured the inside diameter of the Replacement Tripod Base for Brophy Cable Camper Jacks #1106 and found it was 2 inches. This base is a replacement for the Brophy Cable Camper Jacks - 57" Max Lift Height #CJ41 and 67" Max Lift Height…

I would recommend the Timbren Rear Suspension System part #TDR2500D for your 2014 Ram 2500 with coil springs. This system has been confirmed to fit your vehicle that has coil springs and will provide you with additional suspension support when the…

It is typical to have approximately 1/2 inch of space between the bottom of the bumper and the axle. Removing the spacer will help to improve the ride quality. With the spacer gone, the distance increases to 1-1/2 inches, and will improve ride…

We don't have a 7-way splitter like the photo you sent. We instead for applications just like yours recommend using the Mighty Cord 5th Wheel/Gooseneck Wiring Harness w/ 7-Pole Connector - 7' Long #A10-7007 or the 10 foot long #A10-7010. This…

Yes, the TorkLift Custom Frame-Mounted Camper Tie-Downs - Front, part #TLD2142, will be able to fit your 2019 Ram 2500 Quad Cab 4 X 4, even if you have wheel to wheel running boards. There are two two adjustment holes on the side of the Torklift…

Yes, the Torklift Tie Downs part #TLD2142 would fit your 2022 Ram 3500 crew cab and would not interfere with your step bars. Thank you for sending in a picture of the steps!

Torklift has a front camper tie down that fits the 2021 Ram 2500 that has running boards that run under the bed as well with the part #TLD2142. The #TLD2140 you referenced only works if the boards stop at the cab. Then for the rear tie down setup…