Review of HappiJac Camper Tie-Downs - Truck Bed Camper Tie-Downs - LC182910-182971 Video

I'm assuming your 2024 F-250 has the 6-3/4' bed. If that is correct, the right tie-downs are in fact the #TLF3008 and #TL77CR. TorkLift has accounted for the bed access steps on the 2024 model and confirmed these will fit your truck.

There are plenty of people who have installed the HappiJac Camper Tie-Downs #LC182910-182971 over a bed-liner so you shouldn't have an issue. The only problem you could run into is the thickness of the liner might force you to source longer…

Yes, I checked with TorkLift and can confirm the correct set of TorkLift Custom Frame-Mounted Camper Tie-Downs for your 2019 Toyota Tundra Double Cab with 6-1/2' bed, Factory Hitch, and Running Boards (Stop at Cab) is part #TLT3306 for the…

Installing the Union Tee #AL21838 with your #AL57575 will tie the pressure of the two air bags together. So yes, a shift in a very heavy load like a truck camper will potentially result in air being forced from one into the other. The reason I say…

The Brophy tie downs part #TDSF that you referenced are rated for use with any camper that is properly sized for the truck it will be installed in. The Brophy #TDSF mounts into the truck bed stake pocket, where as the Brophy #HSSF tie downs wrap…

The correct HappiJac Custom Tie-Downs for Truck Bed Camper for a 2015 Ford F-250 6-3/4' Bed Cab Length Boards/Rails is part #LC182910-182971. In regards to the running boards/nerf bars, this is only an issue if they extend past the cab. For tie…

It sounds like there was either a short on the electric brake power wire or the wire gauge running to the brakes was not big enough. Since the wires are already damaged, I recommend running 10 gauge wire, like part #10-1-1, from the trailer connector…

The only pin that should be continuously showing 12V power on the 7-Way connector on your vehicle is the 12V power circuit which is normally the black wire but not always. In 7-way wiring the 12V auxiliary power feed is carried on the contact at the…

There are quite a few option on the fit guide when it comes to camper tie downs, more than likely it is working correctly. The fit guide narrows down the correct part using your year, make, model, bed length, step or no step under bed and hitch type,…

You will want to check your overload spring at the bottom of your leaf springs on your 2017 Ram 3500 to see if there is a hole already pre-drilled. If there isn't you will need to drill holes for the TorkLift StableLoad Suspension Upgrade item #…

CR Brophy, the manufacturer of the #HSSF tie downs did not test fit on the 2007 Toyota Tundra, so they can neither confirm or deny the fit. I was told that if the bed is single walled and the lip under the bed side is at least 2 inches wide, the tie…

The correct TorkLift Custom Frame-Mounted Camper Tie-Downs for a 2008 Ford F-350 Short Bed No Step Factory Hitch is part #TLF2012 for the front and part #TLF3004 for the rear. These can then be paired with the TorkLift Locking FastGun Turnbuckles…