Review of Equal-i-zer Trailer Hitch Ball - Trailer Hitch Ball - EQ91-00-6080 Video

The Torflex Lift Kit item #K71-707-01 is the correct kit for a #10 Dexter torsion axle and you won't need to drill any new holes into the spacers. I have attached a couple of pictures below so you can see how they look once installed. I have also…

The Torflex lift kit part #K71-723-01 is the only size lift we have that fits this axle configuration. There isn't a 2-5/8 inch lift available that is similar to it.

The Dexter Torflex Lift Kit #K71-707-02 referenced in your question is designed for the #10 Torflex axle with a 2,300 to 4,000 pound capacity. As you mentioned, the lift kit cannot be used with Torflex axles that use a 3 inch high profile bracket.…

Since you have a Dexter Torflex 3,000 lb trailer axle the correct lift kit is the part #K71-707-01 that you have. The other part number you mentioned is for lighter capacity axles.

We offer two Torflex axle lift kits for Dexter's torsion axles. All you need to check is the axle weight rating, which will appear either on the axle's own identification sticker or on the trailer's main information plate where axle…

Since we know your Dexter Torflex axle is a 2,400 lb axle that would mean that it's a number 10 and the lift kit part #K71-707-01 would be what you'd need. The brake assemblies part #23-47-48 would also be the correct parts as well.

It is certainly possible for any axle to wear out enough over time to need replacing. Since the suspension is built into a torsion axle if the suspension part was to wear out pretty much the only solution would be to replace the axle. If the…

For a 2 inch hitch ball that fits the Equalizer Weight Distribution systems we have the part #EQ91-00-6080. You should note that this has an 8,000 lb trailer weight capacity though.

I have spoken with Equal-i-zer in the past and they have said that you can go with the larger system (to an extend) in light of upgrading the trailer down the line without any adverse side affects. Therefore, the Equal-i-zer Weight Distribution…

I contacted Venture Trailers Inc. and found that the reason they do not recommend the use of a weight distribution system is because most weight distribution systems are not recommended for trailers with surge brakes because they do not allow the…

Because your trailer is a straight-tongue or pole-tongue trailer, you will need a pole-tongue adapter like #RP58393. For a weight distribution system, I recommend Reese Steadi-Flex Weight Distribution with Sway Control part #RP66561. This system is…

Out of our available locking hitch pins, the etrailer, Roadmaster, InfiniteRule, Demco, and Blue Ox locks are made in the USA. Assuming you have a 2" hitch I recommend the etrailer Trailer Hitch Receiver Lock for 2" Hitch - Flush -…