Powerbuilt 12 Point Socket with 3/4 Inch Drive Review Video

The socket needed for the Fastway e2 is the 1-7/8" 12pt Thin Walled Socket #ALL643216.

The recommended ball for the Fastway E2 Weight Distribution Hitch #FA92-00-0800 that you have is 1-1/4 inch in diameter and with a length of 2-5/8 inches. For a 2-5/16 inch ball with those dimensions I would recommend the #C40030.

I went to our warehouse and checked the Replacement Head #FA94-02-1055 for Fastway e2 Weight Distribution Systems and found that it takes a hitch ball with a 1-1/4-inch diameter shank. You can use the link provided to view all 2-5/16-inch hitch balls…

I would be happy to! Weight distribution systems are selected based off of tongue weight which is typically between 10% - 15% of your trailer's total weight. This would put yours between 250 lbs - 375 lbs. There's really only a couple of…

Yes, the Powerbuilt Thin Walled Socket #ALL643216 or the Fastway/Equal-i-zer part #EQ70-00-4800 will allow you to properly torque the hitch ball in your Fastway weight distribution system #FA94-00-1000.

The Replacement Head for Fastway e2 Weight Distribution System #FA94-02-1055 uses a hitch ball with a 1-1/4" shank and the nut on a hitch ball with a 1-1/4 inch shank takes a wrench with a 1-7/8 inch socket. If you don't have a 1-7/8"…

I would recommend that Blue Ox TrackPro #BLU77FR simply because it does not have lift chains like the SwayPro #BXW1006. Both will do a great job but the TrackPro will have a little less movement because of the absence of drop chains. Blue Ox is a…

You will need to use a standard weight distribution kit like the Heavy Duty Trunnion Weight Distribution System #RP66131 for your I-beam trailer. This system would be rated perfectly for your 10k trailer if it was going to be loaded near it's…

I reached out to my contact at Trailer Valet regarding the XL Trailer Dolly #TVXL2 you referenced and he said that they have tested this unit to work well on up to a 7-8 degree incline. Based on the 12 inch run and 1.3 inch rise you listed for your…

Anytime the fully loaded and ready to tow trailer weight is greater than 50 percent of the weight of the tow vehicle, using weight distribution should be considered. When you get the pop-up, hitch it to the vehicle and pay special attention to the…

To replace a hitch ball on the Blue Ox SwayPro Weight Distribution #BLU66FR you will need a 1-7/8" 12pt Thin Walled Socket #ALL643216. This socket will fit inside the opening for the nut that fastens the hitch ball. The socket will require a…

When installing the head unit of your Equal-i-zer weight distribution system such as #EQ37101ET to your Equal-i-zer shank #EQ90-02-4900 you will need to use the bottom two holes to mount the shank. I have added a cutout of the installation…