Review of Dexter Trailer Hubs and Drums - Pre-Greased 3500 LB - 84546UC3-EZ Video

It's very likely you have integrated hub/drums but the fact you have EZ lube spindles does not guarantee that is the case. You'll have to pull off a wheel and see or maybe you can see from the backside of the wheel.…

The difference between the two hubs part #84546UC3 and #84546UC3-EZ is the grease cap that comes with them. The part #84546UC3-EZ includes an EZ lube style of grease cap that has a rubber plug that can be removed for easy access to the zerk…

Yes you can use a Bearing Buddy on your current axle setup but you'll have to remove the zerk/grease fitting. What you have now is an EZ lube spindle which allows you to push grease through the middle of the spindle but you can…

Yes, the Timken Bearing Kit #TMK52VR will fit your 3,500 lb axle as it fits an standard #84 spindle. The only time this kit won't fit with a 3,500 lb axle is if the trailer/axle is made before the 2000's since…

We recommended to repack the wheel bearings on your trailer every 12 months or 12,000 miles. There is not a specific guideline as far as actually replacing the bearings. When repacking them with grease, you will also just want to check for any…

You can mix the LubriMatic Marine Trailer Wheel Bearing Grease #L54FR with the grease that comes in your Dexter Trailer Hub & Drum Assembly #84546UC3-EZ, but if you want an exact replacement then you want to use the LubriMatic Prime…

The #AKEBRK-35L-SA Self Adjusting brake assemblies will adjust themselves as you drive after the initial installation. The front brakes will always bear a bit more of the braking work, because more of the trailer weight is normally on the most…

The etrailer.com Self-Adjusting Brakes #AKEBRK-35-SA will replace both brakes on an axle, but do not come with the hubs. That being said, if the hubs are in good condition, they will not need to be replaced. When you remove the hub, you will need…

I have just what you need. The Lippert 4,000 Lb Axle on a 2017 Gulf Stream Vintage Cruiser 19ERD uses all the same parts as a 3,500 lb axle so the etrailer Trailer Hub and Drum Assembly part #AKHD-545-35-EZ-K would be the correct replacement.

Purchase of the Dexter 10 inch hub/drum #84546UC3-EZ includes: • L44649/L68149 Wheel Bearings • L68111/L44610 Races • 10-19 Grease Seal • Grease Cap with Removable Plug for EZ-Lube Spindles • Spindle Nut and Retaining Washer • Lug Nuts

Thanks for your pictures! That's what Wranglers are meant for. At 4500 pounds, the weight of the secured cargo would exceed the combined safe working load limit of 1,100lbs per tire of the straps being used on the Erickson E-Track…

Replacement toilet floor flanges are universal so it will work, but you can determine the correct one based on the threading of your current flange. They will work with 3" pipes which you need to have as well. - Male Thread: Replacement…