Review of Demco Carts and Tow Dollies - Replacement Disc Brake Rotor - DM03927-92 Video

Thanks for reaching out! The replacement brake pads for your Demco Kar Kaddy SS #DM9713045 can be found as part #DM59VR on our site. This includes parts for both sides of the tow dolly. If you want to replace the whole assembly then you can do so by…

The Replacement Hub Assembly for Demco Kar Kaddy #DM04369 is the only hub assembly we have for the Kar Kaddy's. There is no 5 on 4 bolt pattern, you likely already have a 5 on 4-1/2 bolt pattern. I recommend double checking the measurements. I…

I went out to the warehouse and measured the Replacement Hub Assembly for Demco Kar Kaddy, Tow IT II, or Penske Tow Dolly #DM04369 from the gold piece rearward, and it measured 4-1/4" long.

The brake rotor designed to fit on the #DM04369 is the Replacement 10" Brake Rotor for Demco Tow Dollies - Qty 1 #DM03927-92. I've also listed the other replacement brake parts that are available for the Demco Kar Kaddy tow dolly below. -…

The correct replacement parts for the Demco hub #DM04369 are: - 10" Brake Rotor for Demco Tow Dollies #DM03927-92 - Brake Caliper #DM13825-92 - Brake Caliper Mounting Bracket #DM13920-92 These are the exact replacement parts that work with the…

You have a 3500 pound axle, with a 4-bolt axle flange, spaced 4” apart each. You also have tires and wheels with a 5 on 4.5 bolt pattern. To put brakes on your West Texas Dolly #WTD-35D you will need a left and right trailer brake kit like the…

The Demco Kar Kaddy SS Tow Dolly with Disc Brakes part #DM9713045 uses disc brakes. The design is very similar to that of a modern day automobile. The wheel and hub/rotor are separate components. I have attached a diagram below. The recommended…

Rather than installing hydraulic drum brakes you should look at a Kodiak Disc Brake Kit #K2R35D for your tow dolly. That is the style the new Demco Kar Kaddy X Tow Dolly #DM9713093 uses as it would make for a much better setup that will be easier to…

There is a special jig required to weld on brake mounting flanges such as #4-35. The flange needs to be welded on concentric and square. Square meaning the flange must be a true 90 degrees from the spindle and concentric meaning the gap around the…

In order to determine the correct placement for the brake mounting flange, you will need to put all wheel components together in the proper order on the spindle and then mark the location for the brake mounting flange. The brake mounting flange needs…

Thank you for including a photo of your idler hubs. The Kodiak Disc Brake Kit you referenced, part #K2R35D, requires a standard 4-bolt brake mounting flange in order to mount. The standard 4-bolt square mounting flange that this kit will fit, part…

The Kodiak Disc Brake Kit part #K2R35D that you ordered is designed to fit an idler hub with a 5 on 4-1/2 inch wheel bolt pattern so as long as your idler hub is 5 on 4-1/2 you will not have an issue using your existing hubs. We do not have any hubs…