Review of Demco A-Frame Trailer Coupler - 50-Degree A-Frame Bolt-On Trailer Coupler - DM13205-95 Video

I checked the Featherlite Trailer website for specs on the model 3116 trailer but this part number returned no results. But if your trailer uses an industry-standard 50-degree a-frame design then the Demco A-Frame Trailer Coupler #DM16680-52 will…

The etrailer A-Frame Trailer Coupler w/ Round Jack Hole #CA-5280-RB uses the standard a-frame angle of 50 degrees. The length from the rear of the coupler to where the coupler meets its narrowest point is approximately 9" long. I have…

The Demco 50-Degree A-Frame Trailer Coupler w/ Jack Hole item #DM13205-95 that you referenced will fit a standard a-frame trailer. This is a bolt on coupler so you won't have to borrow a welder. To install you will want to use 3/8 inch, grade 5…

It sounds like you're looking for a replacement a-frame coupler like #CA-5280-RB but in a silver-painted or zinc-plated finish. Please click on the link provided to see all bolt-on standard a-frame couplers for 2-5/16-inch balls. For the…

To install the Demco A-Frame Trailer Coupler #DM16680-52 that you referenced, you will want to use 3/8 inch, grade 5 bolts , approximately 1-1/2 inches long (depending on how you are installing the coupler). You will want to use 5 of these bolts per…

So the standard angle for A-frame trailers where the two beams meet is 50 degrees. So while I can't get you a CAD drawing for the coupler part #CA-5400-B if you are trying to design your trailer to have the correct angle for the A-frame you…

I walked out to our warehouse and pulled the Redline A-Frame Trailer Coupler #CA5100B. At the widest point inside the coupler measured approximately 9-1/4 inches, the narrowest approximately 2 inches and 8 inches between those points. Check out the…

Yes, you will be able to replace your stock coupler with the Demco 50-Degree A-Frame Trailer Coupler #DM13205-95 as long as you have a standard a-frame trailer. I attached a picture below of the dimensions below so you can see if it would work for…

Yes, you can replace your weld-on coupler with a bolt-on. You'll just need to drill the holes. Then, if you wanted to go back to a weld-on later that would be fine too. Just to confirm you can check with the trailer's manufacturer that…

I would use a protractor, see photo, place the protractor on the edge of the inside of one side of the trailer frame and the other inside edge of the trailer frame should be parallel with the 50 degree line on the protractor. Another way to verify…

Yes, so long as you have a standard a-frame trailer you will be able to replace your current welded on coupler with the Demco 50-Degree A-Frame Trailer Coupler w/ Jack Hole - eZ-Latch - Zinc - 2-5/16" Ball - 21K item #DM13205-95. I have attached…

Nearly all A-frame trailer have a 50 degree angle frame so when it comes time to replace the coupler it's actually not that hard to pick out a replacement since basically any A-frame coupler will fit. The coupler part #CA-5100-Z that you…