CargoSmart E Track - E-Track - 3481788 Review Video

According to my research the CellTech trailers looked to have vertical etrack installed directly to the walls, but since you're trailer has the honeycomb paneling that isn't solid all the way through you'll need to install…

The part #DZ91717P has dimensions of 36" long (back) x 18" long (front) x 19-1/2" wide x 17-3/4" tall. If you planned to install it on your trailer like what is seen in the picture I attached there's a…

Your setup would be totally fine. Especially considering this is a bed application where the force will be straight down. Every third hole on the metal side and every other on the wood would be more than adequate and would be super solid.

When mounting vertical e-track, like #E19146, the type of hardware used will depend on what the material of the surface is made of that you are mounting the e-track on. If you are mounting tracks on a standard plywood surface then you could you 1/4…

The Erickson E-Track Trailer Cargo Control tracks, #E19146, are intended to mount to the structural components of a trailer. These locations provide the most secure mounting to ensure your cargo remains stable within your trailer during transport.…

Erickson E-Track should be secured to the mounting surface with no fewer than 2 fasteners per linear foot per side, so for example a 3-foot section would need no less than 8 fasteners. The type and length of fastener depends on the mounting surface…

It depends on how much load you will be applying to the track, what you are holding with it, and how the trailer frame is made. If you can get to the trailer frame, use nuts and bolts to attach through the floor and the metal trailer frame. If you…

The CargoSmart Horizontal or Vertical X-Track - Matte Black - Steel - 667 lbs - 5' Long #3481788 will attach directly to the vertical metal frame on your trailer. You will use Self-Tapping Screw - 1/4" -14 x 3/4" Long - Zinc…

Zinc plated screws are going to be the best option for use with aluminum to resist galvanic corrosion. This corrosion you are referring to is from two dissimilar metals reacting so you want to use the most similar metals when installing your E-track…

If you are using self-tapping screws and attaching the part #E19148 5-foot rails to metal, you would be okay. If you are installing this into wood I would recommend making sure you have the right size fasteners for the 1/4 inch mounting holes, and…

You are correct to a degree. When using the Self-Tapping Screw (Zinc) #FA1131822 to ground to a steel frame, it comes down to what type of steel the frame is constructed of. The Self-Tapping Screw (Zinc) #FA1131822 is ok to be used with galvanized…

Ideally, you'll want some of the hardware attaching the e-track to the trailer floor to also secure to the cross members as well as to the planks that make up the trailer floor. If that's not possible, I'd recommend using a backer plate…