CargoSmart X-Track Rail Road Test Video

Since your 5' x 10' traler has a V-nose, we recommend going with the Adco SFS AquaShed Trailer Cover For Trailers up to 12' Long #290-46002. This will allow a bit of extra room for the V-nose. With the included straps on the…

I have a hardware solution for you. While the CargoSmart X-Track Cargo Organizer #3481788-C does not come with screws, we do carry ones that will work great with the organizer. For wood screws, I recommend the Snap-Loc E-Track Wood Screws #SL49FR.…

The CargoSmart folding track brackets, part #3481744, includes two brackets. So the price you see on the product page is for the pair.

If you plan to use the track exclusively for securing a side by side, I do recommend using E-track for this purpose. It will be plenty strong to support a side by side, and you will be able to get wheel chock and tie down kits that will work…

E-tracks are typically the stronger of the two, but X-track is more versatile since you can mount them horizontally or vertically. Choosing between the two really depends upon how you plan to use them. If you are installing something in a truck…

A lot of covers, like the Adco SFS AquaShed Cover for Bumper Pull Trailer - Up to 14' Long - Gray #290-46003 you purchased, will typically have some type of reinforcement at those common tear points but if your trailer has sharp edges then…

Though there isn't anything specifically for a 6 x 10 v-nose enclosed trailer, we have something that may work for you. Since the v-nose extends the length somewhat, a cover for a bumper-pull horse trailer up to 12 feet could work, depending…

To install the CargoSmart X-Track Cargo Storage Starter Bundle #3481788-S I recommend picking up 4 of the CargoSmart End Piece #3481745 and then installing it using some screws that match the material you're needing to install this into: -…

According to my research the CellTech trailers looked to have vertical etrack installed directly to the walls, but since you're trailer has the honeycomb paneling that isn't solid all the way through you'll need to install…

Luckily, FLOE International is still around. I was able to find that your 10 foot tilt single axle snowmobile trailer used an L44649 inner and outer wheel bearing. Your snowmobile trailer was equipped from the factory with idler hubs that had a 5 on…

You very well could use wheel studs instead of bolts by installing screw-in studs like the 1/2" x 2" Redline #25-53 or #25-51, or the 9/16" x 3" Redline #25-11. Just be sure that the stud is the correct size, the middle opening on…

The Erickson Horizontal E-Track, part #E19148 has 1/4 inch diameter mounting holes spaced 2 inches apart. The screws you use should be at least long enough to go 3/4 inch into the wood you are mounting the track to. The more screws you use the more…