Review of CE Smith Boat Trailer Parts - Roller and Bunk Parts - CE10604G Video

I have a solution for you, but if you've got a Dutton-Lainson Worm Gear Winch like the #DL11002 then you won't be able to use the #DL6456. Instead, you'll need to use the Hex Shaft for Dutton-Lainson Worm Gear Winches #DL406102 and the…

I have attached for you below the bleeding instructions for the Demco DA86 Hydraulic Brake Actuator part #DM72VR. The Powerbuilt Brake Bleeder part #ALL648591 is a handy tool that will assist with this process.

Thank you for all of the information and photos - it really helps give me a good idea of what you have/need. The parts that you asked about are listed below but I will say you may need a new axle as well if the location where the current leaf springs…

This trailer was either set up this way by the manufacturer or the owners had to fabricate some extensions and then attach brackets and the stops to make this set up. Extensions would have to be fabricated by a machine shop or a welder and then you…

I am not familiar with the exact bow stop you have pictured but we do carry a few options such as the Yates Flat Bow Stop for Boat Trailers part #YRJONBLOCK which is what I recommend using. It's designed to be used with a bracket such as the CE…

The inner width of the U-bolt part #7163184UB that you referenced is 3-1/8 inches. Since 2x4 boards are actually 3.5 inches long this would not fit the board width-wise. Length wise it would fit both sizes. For width you'd instead need the part…

Since you've got a boat trailer, you'll want to use something that offers a good level of corrosion resistance. We have two different u-bolts that would work for you, one that's zinc plated #CE15252A and one that's stainless steel,…

The CE Smith Bolster and Swivel Bracket Assembly #CE10000G that you referenced would work well to replace the bunk brackets on your boat trailer. You would be able to set the angle for the bunks that you would like with the #CE10000G also. I attached…

Yes, you can go with hub #AKIHUB-545-2-G-1K since it uses the same bearings and seal size as your regular hub #AKIHUB-440-2-G-1K. Keep in mind that you will also have to switch to wheels with the 5 on 4-1/2 bolt pattern. I would assume you are…

The CE Smith Bolster and Swivel Bracket Assembly part #CE10000G are universal so they can be used in place of pretty much any bunk bracket. If you have angled bunk brackets these would not be an issue because the above bunk brackets can swivel. If…

The speed rating for the Kenda 5.70-8 Bias Trailer Tire with 8" Galvanized Wheel - 4 on 4 - Load Range C part #AM30130 is 65 mph.

Trailer tires actually don't typically wear out from mileage. Normally it's age that does them in as trailer tires begin to dry rot and become unreliable between 4 and 6 years of age. Instead of trying to track mileage on your tires you'd…