Review of BulletProof Hitches Trailer Hitch Ball Mount - Adjustable 2 Ball Mount 2" Hitch - MD204 Video

BulletProof Hitches does not follow the standard measurement like everyone else, which is why you're seeing a difference on the #MD204. This has caused quite a bit of confusion over time. Rise is the distance from the top of the shank to the top…

The Curt Adjustable 2-Ball Mount #C99NR uses Pins #C56NR which are 3/4" in diameter and have a usable length of 3-3/4". You will need the InfiniteRule Lock #IR36FR which is also 3/4" in diameter with a 3-7/8" span to lock the…

I had our warehouse measure the BulletProof Hitches Adjustable 2-Ball Mount for 2" Hitch - 4" Drop/Rise - 14,000 lbs #MD204 you were looking at and from where the gusset meets the shank to the center of the closest hitch pin hole is…

To allow the post of the Ultimate Trailer Jack #322-RDJ-2K to slide up and down, loosen the 3 mounting bolts used to attach to your A-Frame. Check to see if this allows the jack post to move. If it does, you'll want to tighten the bolts by hand…

Since you are not getting the 12V power when your truck is running, you most likely don't have a fuse issue as you stated their isn't a specified fuse or relay in the owners manual. The issue is that your truck is computerized even at the…

Normally trailer coupler height is around 17 inches, from the ground to the bottom of the coupler, and most hitch manufacturers design their hitches to work with a ball mount that will end up very close to this measurement. I am including a link to…

The Flint Hill Goods adjustable ball mount part #FHG92VR would have clearance to work with your Draw Tite hitch #75758 on you 2019 Ford Escape and would give you the 6 inches of rise you are looking for as well.

Starting with the most significant difference here, the BulletProof Hitches Adjustable 2-Ball Mount #MD204 has a different rise/drop when compared to the Curt #C45900. The #MD204 has a 4" drop and a 4" rise while the #C45900 has a 6"…

The 3/8 inch chain would not be a problem but the hook could be depending on its size. If you can't run the chain through backwards or there are hooks on both ends of the chains you have then the hook needs to be less than 1-3/8 inches high and 2…

To lock the Blue Ox Adjustable 2-Ball Mount #BLU75XR to your trailer hitch and the ball mount to the shank section I recommend picking up the Curt Lock Set #C23556. This includes a standard locking hitch pin as well as one that's a bit longer.…

We have the adjustable ball mount #MD204 which has both a 2 inch and a 2-5/16 inch balls. It also provides up to 4 inches of rise or drop.

To level a tandem trailer with the #EZ-JACK you will only need one set of the levelers. For the chocks part #RR-WC-2 you would only need one set of them as well. I attached a picture that shows the EZ-JACK being used on a tandem axle trailer.