Curt Adjustable 2-Ball Mount Review C99NR Video

The TireMinder i10 TPMS #TM38FR refreshes every 6 seconds. You will get a visual and audible alert when the monitor receives the signal from your tire sensor is either below your pressure or the temperature exceeds the maximum setting.

I recommend using the Curt Lock Set #C23556 for your Curt Adjustable 2-Ball Mount #C99NR. This comes with a lock for the hitch receiver and one for the ball mount platform. Even though your platform uses 2 pins, only 1 locking pin is needed to secure…

Because your trailer has a Turning Point pin box and your Ram has a 6.5' bed I do recommend going with a fixed hitch and using the Turning Point as a rotating pin box to give yourself enough turning clearance. With you also having a puck system…

I am not sure what products you are referring to but the most safe, secure, and easy tie down method we offer for your Can-Am Spyder is a combination of the Erickson Horizontal E-Track part #EM19147 (3), the Erickson E-Chock Wheel Chocks part…

The Curt Adjustable 2-Ball Mount #C99NR uses Pins #C56NR which are 3/4" in diameter and have a usable length of 3-3/4". You will need the InfiniteRule Lock #IR36FR which is also 3/4" in diameter with a 3-7/8" span to lock the…

Are you sure about the 165/80-13 tire size? I don't show that as a currently available tire size, could you have meant a 185/80-13? In any event, a 175/80-13 tire measures 24 inches tall x 6.9 inches wide which would be slightly shorter at about…

Yes, the Reese lock will work with the Curt Slim Adjustable 2-Ball Channel Mount #C46KR. You could also use the etrailer #e98882 or any other similar lock with a 5/8" diameter to secure it.

There is a way for you to add a trailer hitch to your 2002 Thomas Saf-T-Liner bus although there are none mounted vertically onto the frame, they will use brackets to mount to the frame which can be bolted or welded on. What you need is the Draw-Tite…

The Curt adjustable ball mount part #C99NR that you referenced weighs 36 lbs.

It sounds like you're looking for the distance from the center of the hitch pin hole to the center of the ball on the Curt Adjustable 2-Ball Mount #C99NR. That measurement is 12-1/4".

The Round A-Frame Trailer Jack #TJA-5000S-B has mounting holes that are elongated. The actual holes are 3/4 inch long and 7/16 inch wide. That gives you a minimum of 2-1/2 inches or maximum of 3-3/4 inches to the nearest or farthest part for…

There really isn't a particular maximum trailer weight that is used to determine when brakes need to be added to both axles of a tandem axle setup. While I do still recommend checking your local laws, I am also not aware of any general laws that…