Bulldog Straight Tongue Trailer Coupler - Standard Coupler - BD028242 Review Video

Yes, the Sleeve-Lock Trailer Coupler #CTA-196 will fit the channel bracket that comes with the Brophy Lunette Ring w/ 3-Position Adjustable Channel Bracket #BR43ZR. The bolt holes match as well when it comes to size and spacing so you'll be…

All axles, including the Trailer Axle with Idler Hubs #e25GR you referenced, are measured by capacity and two measurements (hub-face to hub-face & spring center to spring center). The hub-face to hub-face measurement ensures that your wheels…

We have a few different round tube mount couplers that might work for you. If the tube has a 1-3/4 inch diameter we have 4 options: #BD028381 is rated for 7,000 pounds and fits a 2 inch ball #BD028242 is rated for 5,000 pounds and fits a 2 inch ball…

You will want to use a coupler made to fit on a round tube rather than a square one. We have several options such as #BD028242 or #BD028383. However, these couplers do not have an exact 2 inch measurement so you may need to have some fabrication done…

I went out to the warehouse and took some measurements of the The Bulldog Collar-Lok Coupler w/ Pin for 3" Channel Tongue, part #BD028243. The measurement for the outside width is 3-1/4". The inside width is 3" and the coupler is…

When selecting the correct replacement axle for a utility trailer you will need to know both the hub face (wheel center) and spring center measurements. For example, if your current hub face measurement is 88" and you replace this with an axle…

If they were talking about the hub face and spring center measurements then what was referred to was the hub-face-to-hub-face and spring-center-to-spring-center lengths. Hub face is measured from the base of one wheel stud to the base of the wheel…

It is highly recommended that the spring seat be at minimum tack welded to the axle. There have been issues that have resulted from the seat not be welded to the axle. If you do not have access to a welder, I recommend taking the trailer to a local…

Moving the spring seats that far is not recommended for the reason your friend gave as it doesn't carry the weight evenly. My recommendation for you so you don't need to worry about the springs is to use the Timbren Axle-Less System…

When you replace the axles on a trailer you will look at the (A) hub-face-to-hub-face and the (B) spring-center-to-spring-center measurements and choose an axle that has the same measurements that your current axle does. Since you are wanting to add…

We do not carry any 1-3/4 inch hitch balls. The only option I could recommend for you would be to upgrade the coupler on your trailer to work with the modern ball sizes of 1-7/8, 2, or 2-5/16 inch balls. I attached a page that has all of the couplers…

A #84 spindle, like #TRU24FR , is a spindle for a 3,500 pound axle that has inner bearing #L68149 and outer bearing #L44649. The bearing kit that fits is #BK2-100. To replace your brakes and hubs you'll need the Kodiak Stainless Steel Brake Kit…