Beginner's Guide to RV Awnings: How to Open, Close, and Maintain Your Awning

You can't wait to get to the campsite, kick back, and enjoy a cold drink in the pleasant shade of your RV's awning. First, however, you need to have a grasp on the basics, such as how to open your awning. And how to close it. And if you're going to be opening and closing your awning, you also need to learn how to care for it—and how to avoid unintentional damage.

Watch Now: Tips on RV Awning Care: Opening, Cleaning, and Replacing Your Awning

Watch our video for tips or read on to learn:

How to Open Your Manual or Hybrid RV Awning
How to Close Your Manual or Hybrid RV Awning
How to Maintain Your RV Awning

How to Open Your Manual or Hybrid RV Awning

Opening your RV is a simple process once you've done it a few times. If you have an owner's manual for your awning (or for your motorhome, if your awning is an OEM model), always follow the instructions listed for your particular model. Many owner's manuals can also be found online, if you don't have one. The following guidelines provide general instructions that apply to most RV awnings.

Before you start, it's helpful to have an idea which type of RV awning you have: traditional or hybrid. A traditional awning is fully manual, with spring-loaded arms. With this type, you need to loosen the rafter knobs, walk out the awning, and manually set the tension. With a hybrid system, simply rotate the awning rod to open the canopy. (For more details, read on below.)

Watch Now: Demonstration on opening and retracting a Solera RV awning.

Featured: an awning rafter knob, also known as a tension knob (top) and travel latch (bottom).

Step 1

Undo the travel latch or lock that holds the awning to the side of the RV. If you have a standard spring-loaded awning with small black rafter knobs, loosen the knobs now (just a few turns are necessary—don't remove them or loosen them all the way). Next, do the same to the other side of the awning.

Step 2

Use the awning rod to move locking lever to the "roll down" position.

Step 3

Hook the awning rod into the strap loop. Pull the awning down as you walk backward. If one end gets stuck, you may have to give the arm a gentle tug (or have a partner help) in order to evenly open the awning. Some models require you to twist the awning rod in order to extend the fabric.

Step 4

For spring-loaded awnings, slide the inner arm to the top of the outer arm, apply tension by gently pressing downward on the arms until the fabric is pulled taut, and tighten your rafter knobs. Repeat on the other side.

On models that are not spring-loaded, the arms will automatically stay in place whenver you let go of the road.

Step 5

Adjust the height and pitch (or angle). On some models, this is accomplished by pulling a lever or latch on each arm and raising the awning to the desired height. This is most easily accomplished with two people simultaneously lifting the awning arms. However, it can also be accomplished with one person. Just adjust both sides of the awning in increments until it reaches the desired height.

Newer hybrid awnings can be adjusted by simply pushing or pulling the arm to the desired position without having to bother with levers and knobs.

Tie your strap out of the way when you're finished.

How to Close Your Manual or Hybrid RV Awning

Retracting your manual or hybrid RV awning is easy—just take the steps above in reverse!

Step 1

For standard awnings only: If you have a standard awning with spring-loaded arms, start by lowering both sides of the awning. Then loosen the black rafter knobs and slide the inner arms back toward the RV until they lock into place.

Step 2

Push the locking lever into the "roll up" position. For hybrid awnings that don't lower down as far as standard awnings, use the awning rod to push the lever into the proper position.

Step 3

Holding the strap (with either your hand or the awning rod, depending on your model), walk forward so that the awning rolls up against the RV. Some models require you to twist the awning rod to roll up the fabric. Be careful not to let go of the strap, or the awning will slam against the side of your RV.

Step 4

Be sure the locking lever is in the locked position. Close the safety latches or locks that hold the arms against the RV. Tighten your rafter knobs if your system has them. You are now ready to travel!

How to Maintain Your RV Awning

Like with everything else on your RV, it's important to learn how to properly care for your RV awning to make it last as long as possible. Keep in mind that most insurance companies consider awnings to be an accessory and often don't cover them, so you definitely want to keep your awning in the best possible shape.

Always tilt your RV awning at a slight angle to allow for water runoff.

Tips for Opening and Closing Your Awning:

Do adjust the pitchThe pitch, or angle, of your awning is crucial. Angle one corner of the awning downward to allow water runoff, or invest in an awning with an automatic rain dump feature. (Another tip: steer clear of the dumping location unless you want a quick outdoor shower.)
Don't rip your awning with the doorBe sure your awning clears the top of your door. Also make sure your travel companions are aware when you're opening the awning—the last thing you want is someone unwittingly throwing the door open on your half-open awning and tearing the fabric. Most RV doors these days have rounded corners to prevent this kind of mishap, but it's still a "better safe than sorry" situation.
Do roll up if it's windyMost RVers wonder at some point how much wind their awnings can handle. Unfortunately, the only way to know this for sure is to leave your awning out in high winds and see how long it takes the wind to destroy it. A good rule of thumb to keep on the safe side is that, if you're questioning whether or not it's time to roll up, it's time to roll up. Some awnings even include wind sensors and automatically roll up if they detect winds of a certain speed.
Don't leave the awning unattendedRetract the awning when you leave the campsite to avoid damage from wind, storms, or unnecessary UV exposure.

RV awning clamps secure your awning fabric to its frame to prevent flapping and tears.

Tips for Securing Your Awning

Do use awning clamps Use RV awning clamps to prevent the awning from opening while you drive, and to prevent the fabric from flapping in the wind when extended.

Wash your RV awning regularly to keep it in prime condition.

Tips for Cleaning and Maintaining Your Awning

Do clean your awning regularlyAt minimum you should clean it once a year with dish soap and water before storing your RV for the winter. Ideally, however, you should clean your awning every few months or more frequently, as needed. RV awning cleaner is also available. Read more about cleaning your awning here.
Don't roll up a wet awningDoing so can cause mold and mildew to form on the fabric. If you absolutely have to roll it up wet, open the awning again as soon as possible and allow it to fully dry.
Do clear the awning of leaves and debris before rolling it up Not only will this stuff accumulate and weigh down your awning over time, but it'll also fall on your head and into your eyes next time you open the awning. Been there. Not fun.

7 Steps to Clean Your RV Awning, Prevent Mold, and Save Money

Replacing RV Awning Fabric: Your Step-By-Step DIY Guide

How to Install an RV Awning From Scratch

Related Products

Shop Awning Repair Tape

Shop Awning Lights

Shop Awning Screens

Written by: Amber S.

Updated on: 6/12/2021

Douglas W.

5/22/2021

I have a 2020 Keystone Hideout and I was hoping you can tell me how to adjust the pitch on my power awning.

Jon G.

5/24/2021

I'm not sure what awning you have on your Keystone Hideout but have you tried any of the methods that we mention in step 5 of the "How to Open Your Manual or Hybrid RV Awning" section?

Explore Expert Info

on RV Awnings

Videos

for RV Awnings

Help Articles

for RV Awnings

Expert Answers

for RV Awnings

Review of Dometic RV Toilets - Low Profile Tan Ceramic Toilet - DOM77FR

Review of Dometic RV Toilets - Low Profile White Ceramic Toilet - DOM67FR

Alpha Systems RV Butyl Tape Review

Review of Alpha Systems RV Roof Repair - 1-1/2 Mylar-Backed ButylTape - AL93FJ

Review of Westlake Trailer Tires and Wheels - Tire with Wheel - LHAW320

Review of Lippert Components RV Awning Replacement Arm - LC67VR

Roadmaster Tow Bar Cover Review

Brake Buddy Classic 3 Portable Supplemental Braking System Installation - 2018 Ford Explorer

Lippert Components Trailer Jack LC387874 Review

Best 2016 Ford F-150 Towing Mirror Options

Review of Lippert RV Door Parts - Entry Door Hinge - LC95VR

Surco Universal Exterior RV Ladder Review

Replacing RV Awning Fabric: Your Step-by-Step DIY Guide

Choosing the Right Suspension Kit for Your Truck and Trailer

How to Install an RV Awning From Scratch

Trailer Maintenance Schedule

7 Steps to Clean Your RV Awning, Prevent Mold, and Save Money

Don't Break Your Pipes or Your Wallet: Winterize and De-Winterize Your RV

How to Level Your Fifth Wheel in 3 Simple Steps (Manual or Auto-Level)

How Does an RV Toilet Work?

Best Vehicles to Flat Tow Behind an RV

4-Step Guide to Installing RV Solar Power

How to Service An RV Air Conditioner

Cleaning Your RV Black Water Tank in 4 Easy Steps

Replacement Microwave for Highpoint #EC942K9

I looked up the dimensions of your High Pointe EC942K9E and it's 15 inches deep, 15.7 inches tall, and 29.9 inches wide so the Furrion Over the Range RV Convection Microwave #FMCM15SS would easily fit in place of it and would also work…

view full answer...

Replacement RV Microwave for High Pointe EC942K9E

I looked up the dimensions of your High Pointe EC942K9E and it's 15 inches deep, 15.7 inches tall, and 29.9 inches wide so the Furrion Over the Range RV Convection Microwave #FMCM15SS that you referenced would easily fit in place of it and…

view full answer...

Replacement Pitch Arm Assembly For 63 Inch Long Solera Awing Arms

I believe what you're looking for is the: -Replacement Pitch Arm Assembly for Solera XL 63" Flat Awning Support Arm #LC67VR. This arm measures 33" long, and is a direct replacement for the Solera XL 63" long flat…

view full answer...

How to Measure to Pick Out Replacement Landing Gear for a Trailer

The sure way to pick out replacement landing gear for a trailer that will bolt right up to the current brackets is to measure the distance between the mounting brackets (underside of top bracket to top of lower bracket as shown in the diagram) if it…

view full answer...

Furrion Microwave that Has Vent at Rear

view full answer...

Replacement Deep Cycle AGM Battery for Centennial DC27MF for RV

We have an AGM Group 27 Deep Cycle battery with the Bright Way part #BRW94FR that would work great. This can support 100 amp hours at 20 hours so it will do a great job holding a charge.

view full answer...

Replacement Hub for 2013 Wildwood 26TBSS Hub Drum with AL-KO 8700

The AL-KO trailer hub part number 8700 that you have is a 3,500 lb trailer hub/drum with a 5 on 4-1/2 inch bolt pattern. Based on that the #AKHD-545-35-EZ-K is the correct fit and would work great.

view full answer...

Brake Shoe Thickness and When to Replace Dexter 3,500 Brake Pads

I went out into our warehouse to measure the pad thickness of a Dexter 3,500 10 by 2-1/4 inch brake assembly like the part #23-468-469 and just the brake pad portion of the shoe measured .18 of an inch. The entire shoe thickness was .29 of an inch…

view full answer...

How Thick Are Electric Brake Shoe Pads and When Should They be Replaced

On Dexter 12" Nev-R-Adjust Electric Brake Assembly #23-458 the shoe pad thickness is 3/16 of an inch. Dexter says that you should replace the shoes if the material gets down to 1/16 of an inch thick or less.

view full answer...

Location of the Factory Brake Controller Plug In Location on a 2005 Dodge Dakota with Tow Package

The female socket that the Tekonsha Brake Controller Adapter, item #3020-P, will plug into, is located under the dash on the left side just above the emergency brake pedal, see photos at right. Normally this connector is blue and it is located in…

view full answer...

Can You Run a Washing Machine, TV and Vacuum on an Inverter

The Go Power Industrial Pure Sine Wave Inverter #34278156 has a running output of 2,000 watts. From what I could find researching running washing machines off of an inverter, it is going to depend on the machine and even whether you are using hot or…

view full answer...

Replacement Gearbox for Solera Manual Crank Style Awning Drive Head LC300031

The gearbox inside of the Solera Manual Crank Style Awning Drive Head part #LC300031 is not available separately as a replacement part therefore if you need to replace this you will have choice but to replace the entire assembly.

view full answer...

Departments

Towing

Sports and Recreation

Trailer Parts

Vehicle

Contact & Help

What our customers are saying:

"WOW! I am impressed! I called to place my order and real person answered, spoke perfect English, albeit a slight southern accent, and my order was sent within a day, shipped quickly and I had it a few days later. I saved over a hundred dollars over local and installed it my self. I cant imagine how that they could do any better. THANKS!"

Eric

Cedar Springs, MI