Videos
for Search Results
Help Articles
for Search Results
Expert Answers
for Search Results
Hey Don; good question and no other parts - including any type of adapter plate or mounting plate - is needed to mount the 30 Amp Go Power PWM Solar Charge Controller with Bluetooth #GP76QR. The #GP76QR comes with screws and is ready to be mounted…
view full answer...The side plates of the B&W gooseneck trailer hitch #BWGNRK1313 will mount on the outside of each frame rail of your 2004 Dodge 2500 8-foot bed. See the B&W video I included at the 7 min and 30 second mark. If your Firestone air bags…
view full answer...Hi Donald, Yes, a higher amperage charger, like the #GP76QR (30 amp), would be able to provide a faster recharge for your battery bank than a 10 amp controller like the #34280503. When adding in the second battery you'll want to wire it in…
view full answer...You can use the Loctite RTV 598 High-Performance Silicone Gasket Maker #LT37467 as a sealant. You'll just want to put this sealant in between the two surfaces.
view full answer...I sure can! A 14x5.5J wheel has a 5 on 4-1/2 lug pattern. You can use the Loadstar ST215/75D14 Bias Trailer Tire with 14" White Wheel - 5 on 4-1/2 - Load Range C item #AM3S550 as a spare.
view full answer...The 125255UC seal has a 1.249" ID and a 1.983" OD and for that our part #34823 will be the correct replacement.
view full answer...No, you do not need to install a separate diode on your 2024 Ford Maverick when installing the Roadmaster Battery Charge Line Kit for Towed Vehicles #RM-156-25.
view full answer...The 7290 that you see is a casting number. It is found on AL-KO hubs that fit #99 spindles. I found that the bearings used are #28580 which would be the inner bearing and #25580 which would be the outer bearing. For the seal use #91030.
view full answer...The Roadmaster Battery Charge Line Kit part #RM-156-25 would be the kit you would need to charge the battery of your 2015 Nissan Xterra when it is being flat towed. This type of charge setup does not require a diode nor does it have potential to…
view full answer...The purpose of a diode is to stop the back flow of electricity. I can honestly say I have never heard of someone wanting to run a charge line from the trailer battery to the vehicle battery but I'm sure it would be possible. That said, when you…
view full answer...The 2.5-Watt Solar Battery Charger #PTW2997 cannot remain connected while the engine is running. The installation instructions from the manufacturer (which are attached) state "CAUTION: Disconnect the solar battery charger from automotive 12 V…
view full answer...People do prefer to use 6v batteries in series because they can better handle 50% discharge cycles than a 12v will. They also tend to have more charge/discharge cycles in their lifetime compared to a standard 12v. That being said, the abilities of…
view full answer...Filter Your Search
Contact and Help