Hitch Recommendation for a 2015 Honda CR-Z

Question

Question:

I need a hitch for my 2015 Honda CR-Z, will this fit?

asked by: G,ritman

0

Expert Reply:

The Curt Hitch part # C11077 that you referenced has been confirmed to fit your 2015 Honda CR-Z so I would recommend it for you.

For a ball mount you would want the # C45520, and then for hitch balls # 19256 and # 19258.

expert reply by: Jameson C

0

Answer 1

The issue you are describing is actually not terribly uncommon. Occasionally, a newly installed trailer hitch will come very close or make contact with a vehicle's exhaust system, even when everything is installed properly. We actually have…

view full answer...

Answer 2

According to the instructions for Curt trailer hitch #C11077 you will need to trim the underbody panels to remove the area where plastic clips attach the panel to the frame rails. I have linked the instructions and also included a picture from them…

view full answer...

Answer 3

It is difficult to determine what is causing a rattling noise without actually being able to see the vehicle, but I can give you some tips on where to look if you are comfortable crawling under your vehicle to look at the hitch. The alternative…

view full answer...

Answer 4

Yes, the Curt Trailer Hitch Receiver #C11077 is confirmed fit for 2014 Honda CR-Z. I verified with my contact at Curt manufacturing that you will have no issues installing #C11077 on the EX model. There is no drilling required for installation. The…

view full answer...

Answer 5

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 6

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 7

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 8

Class I and Class II hitches both have a 1-1/4 inch receiver opening. The difference is that a Class I hitch has a lower tongue weight rating, usually 200 pounds and a lower towing rating, usually 2,000 pounds. A Class II hitch usually has a tongue…

view full answer...

Answer 9

I did some checking and the hub/drum we offer that will work for you is the part #8-430-5UC3. This uses the same bearings as the 8-415 and will be an exact fit aside from the fact this is a non-ABS setup and the 8-415 came in an ABS setup and non-ABS…

view full answer...

Answer 10

To replace your NOK AD2527E seal you can use #168233. It has an inner diameter of 1.688 inches and an outer diameter of 2.332 inches. Based on what I could find on the NOK AD2527E the inner diameter is the same and the outer diameter is 2.328 inches.…

view full answer...

Answer 11

Lance does have a proprietary plug, but many customers see a standard 6-way or 7-way round and notice it doesn't fit their factory 7-way as well. I've attached an article to help if you have one of the 7-way or 6-way round connectors which we…

view full answer...